62 63
<Cautions Following All-Reset>
· After performing the all-reset procedure, the time will not be displayed correctly
due to the reference position having shifted unless the reference position is set with
the crown at both the first and second positions. Always make sure to set the
reference position.
· After performing the all-reset procedure, the time shown after setting the reference
position is 0:00 AM. When setting the time manually, set both the time and date
while paying attention to AM and PM so that the time is set correctly.
Note: If the crown is accidentally pushed in too far to the normal position when the
crown is pushed in from the second position to the first position, since this will
end setting of the reference position causing the hands to move normally, it will
not be possible to set the reference position for the hour hand and date. If the
crown has returned to the normal position, set the reference position by referring
to “10. B. Setting the Reference Position”. Alternatively, repeat the all-reset
procedure again.
(3) Return the crown to the normal position.
· When the reference position is set after performing the all-reset procedure, the
second hand begins one-second interval movement a few seconds after the crown is
returned to the normal position. Do not pull out the crown until the second hand
begins one-second interval movement.
(4) Perform free reception or set the time and date manually.
