22 23
6. Setting the Time
[Procedure for Setting the Time]
1. Pull the crown out to Position 1 (the second hand rapidly advances to the 30 seconds
position and waits).
Note: If the second hand does not stop at the 30 seconds position, refer to the section
on “Reference Position Correction” of “4. Hand Reference Position Check and
Correction” and set the reference position of the second hand.
2. Turn the crown to align the mode hand at the time mode [TME].
3. Pull the crown out to Position 2 (time correction position).
• The second hand rapidly advances to the 0 seconds position and stops.
4. Turn (click) the crown to set the 24 hour hand, hour hand and minute hand to the
current time.
A Turning the crown one click to the right advances the 24 hour hand, hour hand
and minute hand by one minute.
B Turning the crown by one click to the left moves back the 24 hour hand, hour
hand and minute hand by one minute.
• Turning the crown continuously (rapidly by two clicks or more) causes the 24 hour
hand, hour hand and minute hand to move continuously.
• Turn the crown to the left or right to interrupt continuous movement of the hands.
The hands will continue to advance by 12 hours and then stop automatically unless
movement is interrupted by turning the crown to the right or left.
• The 24 hour hand moves in coordination with the hour hand. Make sure to set AM
and PM correctly when setting the time.
5. Return the crown to the normal position in synchronization with a telephone time
signal or other time service.
Hour hand
Mode hand
Minute hand
(2) Time correction position
(0) Normal position
Button (A)
24 hour hand
Second hand
