300218
22
Zoom out
Zoom in
Previous page
1/28
Next page
18 78-16335-01
Troubleshooting Your Phone
Refer to the following table for some general troubleshooting information for your phone.
Problem Explanation
The phone Hold and Menu
buttons are lit or flashing after
the phone is connected to power
Your phone did not initialize correctly. Contact your system
administrator who will help you troubleshoot the problem.
No dial tone Check that all the cable connections are secure and that the phone
is properly connected to power. See the “Connecting Your Phone”
section on page 4.
If necessary, contact your system administrator who will help you
troubleshoot the problem.
The phone does not ring. Check the ring volume setting. See the “Adjusting the Volume
section on page 15.
The Menu button was
accidentally pressed and you
entered the IVR system.
Hang up the phone to exit. This resets the phone.
The phone Hold button flashes
red and the Menu button flashes
green at the same time.
The phone’s firmware is being upgraded. After the upgrade, all
LEDs on the phone should be off.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ip 7902g at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ip 7902g in the language / languages: English as an attachment in your email.

The manual is 0,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info