604995
11
Zoom out
Zoom in
Previous page
1/52
Next page
4004041 Rev C 11
Front Panel Components
Front Panel Components
The following illustration shows the function of the front panel LED status
indicators on the DPX2203 and EPX2203 and the optional battery pack.
Note: The model shown here is the DPX2203. The EPX2203 does not attach to a
battery pack.
1
REPLACE BATTERY—Illuminates to indicate that the battery could not be fully
charged. While the battery may be able to provide some backup power, it should be
replaced to restore maximum capacity. Contact your cable service provider for
instructions to replace and dispose of the old battery.
2
BATTERY LOW—Illuminates to indicate that approximately 20 percent of charge is
remaining in the battery
3
AC POWER—Illuminates when the cable modem is operating on AC power. AC
power must be available to recharge the battery
4
LINE 2—Illuminates solid green when the telephone line 2 is in use
5
LINE 1—Illuminates solid green when telephone line 1 is in use
6
PC—Illuminates solid green to indicate that an Ethernet/USB carrier is present. Blinks
to indicate that Ethernet/USB data is being transferred between the PC and the cable
modem
7
CABLE—Illuminates solid green when the modem is registered on the network and
fully operational. This light blinks to indicate one of the following conditions:
Booting up and not ready for data
Scanning the network and attempting to register
Lost registration on the network and will continue blinking until it registers again
Blinks very slowly (once every 5 seconds) to indicate that Cable Modem Access
Protection is enabled
8
SEND—Blinks to indicate that the modem is sending data to the cable network
9
RECEIVE—Blinks to indicate that the modem is receiving data from the cable network
10
POWER—Illuminates solid green to indicate that power is being applied to the cable
modem
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco DPX2203 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco DPX2203 in the language / languages: English as an attachment in your email.

The manual is 7,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info