650695
72
Zoom out
Zoom in
Previous page
1/136
Next page
Configuring the Voice Settings
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Cisco SPA100 Series Administration Guide 80
1
Line 1 and Line 2 Settings (PHONE 1 and PHONE 2)
Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for calls through the
PHONE 1 and PHONE 2 ports.
Enter the settings as described below. After making changes, click Submit to save your
settings, or click Cancel to redisplay the page with the saved settings.
NOTE In a configuration profile, the FXS parameters must be appended with the appropriate numeral
(for example, [1] or [2]) to identify the port to which the setting applies.
General
Streaming Audio Server (SAS)
Field Description
Line Enable To enable this line for service, select yes. Otherwise, select no.
Default setting: yes
Field Description
SAS Enable To enable the use of the line as a streaming audio source, select
yes. Otherwise, select no. If enabled, the line cannot be used for
outgoing calls. Instead, it auto-answers incoming calls and streams
audio RTP packets to the caller.
Default setting: no
SAS DLG Refresh
Intvl
If this value is not zero, it is the interval at which the streaming
audio server sends out session refresh (SIP re-INVITE) messages
to determine whether the connection to the caller is still active. If
the caller does not respond to the refresh message, the ATA ends
this call with a SIP BYE message. The range is 0 to 255 seconds (0
means that the session refresh is disabled)
Default setting: 30
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco Cisco SPA112 VoIP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco Cisco SPA112 VoIP in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info