650695

Cisco Cisco SPA112 VoIP Manual

69
Zoom out
Zoom in
Previous page
1/136
Next page
Configuring the Voice Settings
Regional
Cisco SPA100 Series Administration Guide 77
1
Conference Act Code If this code is specified, the user must enter it before dialing the
third party for a conference call. Enter the code for a conference
call.
Default setting: blank
Attn-Xfer Act Code If the code is specified, the user must enter it before dialing the
third party for a call transfer. Enter the code for a call transfer.
Default setting: blank
Modem Line Toggle
Code
Toggles the line to a modem. Modem passthrough mode can be
triggered only by pre-dialing this code.
Default setting: *99
FAX Line Toggle
Code
Toggles the line to a fax machine.
Default setting: #99
Media Loopback
Code
Use for media loopback.
Default setting: *03
Referral Services
Codes
These codes tell the ATA what to do when the user places the
current call on hold and is listening to the second dial tone.
One or more *codes can be configured into this parameter, such as
*98, or *97|*98|*123, etc. The maximum length is 79 characters.
This parameter applies when the user places the current call on
hold by pressing the hook flash button. Each *code (and the
following valid target number according to current dial plan)
triggers the ATA to perform a blind transfer to a target number that
is prepended by the service *code.
For example, after the user dials *98, the ATA plays a special dial
tone called the Prompt Tone while waiting for the user the enter a
target number (which is checked according to dial plan as in
normal dialing). When a complete number is entered, the ATA
sends a blind REFER to the holding party with the Refer-To target
equal to *98 target_number. This feature allows the ATA to hand
off a call to an application server to perform further processing,
such as call park.
The *codes should not conflict with any of the other vertical
service codes internally processed by the ATA. You can empty the
corresponding *code that you do not want the ATA to process.
Default setting: blank
Field Description
… 69 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco Cisco SPA112 VoIP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco Cisco SPA112 VoIP in the language / languages: English as an attachment in your email.

The manual is 1,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info