497619
40
Zoom out
Zoom in
Previous page
1/74
Next page
4-4
Cisco ASA 5500 Series Hardware Installation Guide
78-17989-01
Chapter 4 Maintenance and Upgrade Procedures
Removing and Replacing a Lithium Battery in the SSM
Removing and Replacing a Lithium Battery in the SSM
To remove and replace the battery in the SSM, perform the following steps:
Step 1 Remove the two screws at the left rear end of the chassis, and remove the slot cover as described in
“Installing and Replacing the Intelligent SSM” section on page 4-20.
Step 2 Slide the metal clip back and pull the battery out.
Step 3 Place the used battery aside.
Step 4 Replace the battery with a compactible Lithium CR-2032 battery (which is available at your local electronics
or drug store), by sliding the metal clip back and sliding the battery into place.
Step 5 Replace the chassis cover as described in the “Installing and Replacing the Intelligent SSM” section on
page 4-20.
Removing and Replacing the Power Supply
For information on power supply considerations including environmental operating ranges and power
requirements, see table 7 at the following url:
http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/product_data_sheet0900a
ecd802930c5.html
For information on AC-input power cord options, see Table 2-1in the “Power Supply Considerations”
section on page 2-4
This section describes how to remove and replace the power supply, and includes the following topics:
Removing the AC Power Supply, page 4-4
Replacing the AC Power Supply, page 4-6
Removing the AC Power Supply
To remove the AC power supply, perform the following steps:
Step 1 Power off the adaptive security appliance.
Step 2 Remove the power cord and all other cables from the chassis.
Step 3 Remove the chassis from the rack if it is rack-mounted.
Step 4 Remove the chassis cover. See the “Installing and Replacing the Intelligent SSM” section on page 4-20
for more information.
Step 5 Place the chassis in an ESD-controlled environment. See the “Working in an ESD Environment” section
on page 4-3 for more information.
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco ASA 5510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco ASA 5510 in the language / languages: English as an attachment in your email.

The manual is 1,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info