65671

Cisco 7931G Manual

233
Zoom out
Zoom in
Previous page
1/266
Next page
9-23
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.1
OL-14587-01
Chapter 9 Troubleshooting and Maintenance
Monitoring the Voice Quality of Calls
Using Voice Quality Metrics
To use the metrics for monitoring voice quality, note the typical scores under
normal conditions of zero packet loss, and use the metrics as a baseline for
comparison.
It is important to distinguish significant changes from random changes in metrics.
Significant changes are scores that change about 0.2 MOS or greater and persist
in calls that last longer than 30 seconds. Conceal Ratio changes should indicate
greater than 3 percent frame loss.
MOS LQK scores can vary based on the codec that the Cisco Unified IP Phone
uses. The following codecs provide these maximum MOS LQK scores under
normal conditions with zero frame loss:
• G.711 codec gives 4.5 score
• G.729A/ AB gives 3.8 score
• G.728/iLBC gives 3.9 score
Note • CVTQ does not support wideband (7 kHz) speech codecs, as ITU has not
defined the extension of the technique to wideband. Therefore, MOS scores
that correspond to G.711 performance are reported for G.722 calls to allow
basic quality monitoring, rather than not reporting an MOS score.
• Reporting G.711-scale MOS scores for wideband calls through the use of CVTQ
allows basic quality classifications to be indicated as good/normal or
bad/abnormal. Calls with high scores (approximately 4.5) indicate high
quality/low packet loss, and lower scores (approximately 3.5) indicate low
quality/high packet loss.
• Unlike MOS, the Conceal Ratio and Concealed Seconds metrics remain valid
and useful for both wideband and narrowband calls.
A Conceal Ratio of zero indicates that the IP network is delivering frames and
packets on time with no loss.
… 233 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cisco 7931G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cisco 7931G in the language / languages: English as an attachment in your email.

The manual is 5,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cisco 7931G

Cisco 7931G Quick start guide - English - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info