EnglishEnglish
19
5
19
23
5
dt 1
dt 2
Position a suitable container for the amount to be programmed under
the hot water pipe (5).
Press (and keep momentarily pressed) the hot water dispensing push
button (19). The indicator light of the pressed push button will remain
on (not flashing).
When the amount of water in the container reaches the required level,
release the push button (19).
Programming the hot water measures
1 - Alternately press the PROG button until the display shows:
2 - Press the button to program; the display will show:
The LEDs of the buttons to be
programed turn on.
To change, press “+” or “-”.
Dosage Programing
Press a Button
Selection 01
Water Dosage: 00
Using the PROG button:
Machine messages
WATER-SOFTENER RESIN-REGENERATION MESSAGE
When you hear a beep and the message is
displayed:
l carry out resin regeneration
l Press the “>>>” button for about 8 sec. When you hear the beep, the
message is cleared and “Regeneration Performed” is dispayed.
Resins Regeneration
then press >>>
Machine cold
Please Wait
When the display shows
Wait for the boiler to reach working pressure
as indicated by the gauge.
When the display shows
Grind size is probably too fine.
Coffee panel pressing is probably too high.
Irregular dose
NOTE: If the messages do not clear, request technical service.
