585815
12
Zoom out
Zoom in
Previous page
1/24
Next page
12
Installation instructions
Before beginning with installation, be sure to observe our recommendations
and safety instructions. Some parts are preassembled.
Remove all parts from the carton and assemble the kicker on a soft and
clean surface if necessary, place the transport carton underneath to avoid
damaging/scratching the parts. You can shorten up the assembling time by
using a second person
Step 1
Put the long side boards (1) with top side on the floor and place the playing
field (3) as figure shows into appropriate position of long side board (2). Note
that the playing ground (3) must placed into the right direction
Step 2
Place the short side boards (2) to the long side boards (1) and screw them
tightly by using screws (11),
barrel nuts (6) and washers (8). Put one washer (8), one spring washer (9)
and one nut (10) on one end of each support rods (7). Lay the field support
braces (5) onto bottom side of playing field (3) and put the support rods
(7) though the holes of long side boards (1). Screw the playing field (3) and
field support braces (5) tightly by using support rods (7), washer (8), spring
washer (9) and nut (10). (Attention: Don’t screw them too tighten, so that
the playing field (3) will be bended.)
Step 3
Slide the grip rods (17+18+19) through the bearing holes on one side of
long side board till the middle of playing field. (Attention: The handgrip will
push on the end with hole of grip rod.) Put on each rod a bumper (23) and a
washer (24) and the appropriate players (20+26) and bushings (25). Finally
put on each rod a washer (19) and bumper (18). (Please pay attention of the
right qty, direction and colour of players.) Now, slide the grip rods through
the other holes of long side board. Fix the players (20+26) and bushings
(25) with screws (12) and nuts (13) tightly.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Christopeit LIVERPOOL 13 in 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Christopeit LIVERPOOL 13 in 1 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info