Manual Christopeit FXM 2 (page 27 of 68) (English, German, Dutch, French)

793196

Zoom out

Zoom in

1/68

English

Beginner 1-4 / Advance 1-4 / Sporty 1-4

1. Turn UP/DOWN (+/-) –turnkey to select workout program, choose one

Program and press MODE (F) -key to enter.

2. Turn UP/DOWN (+/-) –turnkey to preset workout TIME.

3. Press START/STOP –key to start workout.

4. During workout, user can turn UP/DOWN (+/-) –turnkey to adjust load

level.

5. Press START/STOP –key to break workout. Press RESET (L) –key to

reverse to main menu.

Cardio mode:

1. Turn UP/DOWN (+/-) –turnkey to select workout program, choose Car-

dio and press MODE (F) –key to enter.

2. Turn UP/DOWN (+/-) –turnkey to select 55%, 75%, 90% or TAG (TAR-

GET H.R. (default 100)

3. Turn UP/DOWN (+/-) –turnkey to preset workout TIME.

4. Press START/STOP –key to start or stop workout. Press RESET (L) -key

to reverse to main menu.

5. During workout, if no hand pulse detected, console will stop to reminder.

Watt: unabhängiges Wattprogramm:

1. Turn UP/DOWN (+/-) –turnkey to select workout program, choose WATT

and press MODE (F) –key to enter.

2. Turn UP/DOWN (+/-) –turnkey to preset WATT target (default: 120).

Press MODE (F) –key to conﬁrm.

3. Turn UP/DOWN (+/-) –turnkey to preset TIME.

4. Press START/STOP –key to start or stop workout. Press RESET (L) -key

to reverse to main menu.

5. During workout, user can turn UP/DOWN (+/-) –turnkey to adjust WATT

target.

Body Fat mode:

1. When workout stop, press BODY FAT (Körperfett) -key.

2. Hold on hand pulse sensor, after 8 seconds, computer will show BMI,

FAT% and fat symbol.

3. Press BODY FAT (Körperfett) -key again reverse to main menu.

B.M.I. (Body Mass Index)

Body Fat:

Test-Recovery:

1. When pulse value display on the computer (hold handgrip), press RE-

COVERY (Test) -key.

2. TIME shows „0:60“ (seconds) and start counting down to “00:00”.

3. Computer will show F1 to F6 after count down to zero to test heart rate

recovery status.

F 1 ~ F6 = RECOVERY

1. Pulse Rate:

The whole set of heart rate detector include 2 sensors each side. Each

sensor has 2 pieces of metal parts. The correct way to detect is, to hold

gently both metal parts each hand. With the good signals picked up by

the computer, the heart symbol in the HEART RATE Display shall ﬂash.

Sometimes the heart rate value is not useable, based on wet hands or

any other contact problems during exercising. If you need high accuracy

heart rate value, you have to use an external heart rate measurement with

a pulse belt.

2. Cardio Pulse measurement:

For pulse measurement, the pulse measuring unit 9309 must be in place.

The use of the pulse measuring unit makes it possible for you to accurately

monitor your own training programme by exact, real-time measurement

of your heart rate. The installation of the system is very simple and easily

done.

The pulse measuring unit was developed especially for use with this ma-

chine. The user puts on the unit and the transmitter of the unit registers

the ECG signals of the heart. The transmitter ampliﬁes the ECG signals

and transmits them in the form of radio signals to the receiver installed in

the computer.

The transmitter switches on automatically when the pulse measuring unit

is put on and the rear of the pulse measuring unit have made contact with

the breast. Any kind of normal training clothes may be worn over the pulse

measuring unit. The receiver installed in the computer receives the signals

from the transmitter and transfers these in the form of electrical impulses

to the computer. The computer processes the signals and displays them

as pulse beats per minute on the display.

To attain an optimum performance of the pulse measuring unit, the machi-

ne should be set up for training in such a manner that it is as far as possible

from all high-voltage power lines, electric motors and other sources which

can cause interference. Adjust the strap to your chest measurement and

put on the entire unit as depicted in the illustration. Ensure that the strap

is not too loose and that the transmitter is located at the centre of your

chest. The unit and thereby the pulse measuring system is then installed

and ready for use.

Clean the pulse measuring unit after each training session with a cloth

moistened with a soap solution and then with a cloth moistened with pure

water. This prevents the accumulation of sweat which could lead to inac-

curate measurements.

SYMBOL - + u

FAT% - Low Low/Medium Medium Medium/high

Gender

Male <13% 13%-25.9% 26%-30% >30%

Female <23% 23%-35.9% 36%-40% >40%

1.0 Outstanding

1.0 < F < 1.9 Excellent

2.0 < F < 2.9 Good

3.0 < F < 3.9 Fair

4.0 < F < 5.9 Below average

6.0 Poor

B.M.I Scale Low Low/Medium Medium Medium/high

Range <20 20-24 24.1-26.5 >26.5

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Christopeit FXM 2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3.6 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Christopeit FXM 2 Manual

Product: