574366
7
Zoom out
Zoom in
Previous page
1/17
Next page
IRIS Touch Home Series Installation Manual 7 of 17
4. Installing the IRIS Touch Home
Use the following procedure to install the IRIS Touch Home. The procedure below describes
that used for dual path operation. Where single path is being used please step over the
instructions for the path not being used (Ethernet or GPRS).
Refer to Figures 5 and 6 for cabling and connections.
1. Determine which powering mode to use (see above).
Do not apply power to the dialler until indicated.
2. Decide where to run the cables
Decide the best way to run the cables that will be required. Panel dialler interface
cable, Ethernet cable and/or GSM Antenna.
This can be either:
g Behind the unit (through the wall).
g Through the bottom of the back plate of the unit via the ‘knock outs’.
3. Disassemble the IRIS Touch Home
Remove the two case fixing screws and open the unit and remove the IRIS Touch
dialler PCB.
Note:
The IRIS Touch PCB is retained by two clips located at the bottom of IRIS
Touch PCB.
4. Mount the housing on the wall
Position the IRIS Touch Home housing on the wall. Drill three holes, put the cables
through the opening at the base of the plate, or via the ‘knockouts’, and secure the
plate to the wall with the three screws supplied.
5. Fit the batteries
Fit the eight batteries, taking care that the orientation is correct. This is shown in
Figure 5.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chiron IRIS Touch Home at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chiron IRIS Touch Home in the language / languages: English as an attachment in your email.

The manual is 11,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Chiron IRIS Touch Home

Chiron IRIS Touch Home Installation Guide - Dutch - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info