the wheel from the fork, carrying out the above operations in the
reverse order.
WARNING: Check that the wheel unit is safely locked into position.
WARNING: Always check that the lever is locked correctly.
HOW TO FIT/REMOVE THE REAR WHEELS
7. Insert the joint of the wheel into the correct slot, until a “clak” is
heard, signalling that it is locked into position; repeat the operation
with the other rear wheel (diag. 7).
8. To remove the wheels, raise the release buttons shown in
diagram 8, and remove the first wheel. Repeat the operation with
the other rear wheel.
WARNING: Check that the wheel units are fitted correctly.
The wheels may be removed to make the stroller more compact
when closed.
HOW TO FIT/REMOVE THE FABRIC COVER
9. Insert the small round plastic devices, located at the sides of the
fabric cover, into the slots inside the tubes (diagram 9 A); ensure that
they are completely fitted to the end of the slots (diagram 9 B).
10. WARNING: The crotch strap is fixed to the seat support of the
frame (as shown in diag. 10 A): To use the crotch strap correctly,
slide it through the hole of the cover, as shown in diagram 10 B.
To use the safety harness correctly, please refer to the paragraph
“How to Use the Safety Harness”.
11. Fasten the 2 press studs (diagram 11).
12. Fit the two cover flaps of the armrests, inserting the plastic joints
of the cover into the holes located on the armrests (diag. 12).
13. Before fitting the seat to the frame, check that the adjustment
strap of the backrest (component A of diag. 13) is inserted correctly
inside the holes B. If it is not fitted correctly, insert the strap A
inside the two holes B.
14. Then fasten the 5 spring catches located on the fabric cover
to the spring catches located on the frame, operating as shown in
diagram 14.
WARNING: Check that the fabric cover is fitted correctly to the
frame of the stroller.
HOW TO USE THE SAFETY HARNESS
This stroller has a 5-point safety harness featuring two shoulder
straps, a waist strap and a crotch strap with buckle.
WARNING: When using the safety harness with children from birth
up to approximately 6 months of age, it is necessary to first fit the
shoulder straps through the two adjustment holes on the fabric
backrest.
15. Check that the shoulder straps are at the correct height for your
child. If they are not at the correct height, insert them into the
holes of the fabric cover to adjust them correctly (diag. 15).
16. After sitting your child in the stroller, insert the 2 prongs into
the buckle and, if necessary, adjust the waist strap operating the
buckles (diag. 16).
17. To unfasten the waist strap, press and pull at the same time the
side prongs (diag. 17).
WARNING: Children should be harnessed in at all times. To ensure
your child’s safety, it is necessary to always use the safety harness.
HOW TO ADJUST THE BACKREST
The backrest can be adjusted through a belt adjustment system.
18. To lower the backrest, it is necessary to operate the rear
adjustment system. Press the two side buttons, as shown in diag.
18, adjusting the backrest until the desired position has been
reached.
Vice versa, to raise the backrest, it is necessary to press the two
side buttons of the adjustment system, and pull the strap until the
desired position has been reached.
WARNING: The child’s weight can make these operations difficult.
REMOVABLE BUMPER BAR
19. To remove the bumper bar, press the two buttons located on
the inner side of the armrests (diag. 19), and pull the bumper bar
towards you.
WARNING: Never use the bumper bar to lift the stroller with the
child sitting in it.
HEIGHT ADJUSTABLE HANDLE
To make the stroller more ergonomic and compact, it is possible to
adjust the height of the handle.
20. To lower or raise the handle of the stroller, operate the external
buttons, and adjust the handle to the position that you find most
comfortable (diag. 20).
SAFETY BRAKE
The safety brake locks both of the rear wheels of the stroller at
the same time.
21. To operate the brakes of the stroller, push the lever located
between the rear wheels in a downward direction, as shown in
diagram 21. To release the brake, pull the lever located between
the rear wheels in an upward direction.
WARNING: Always apply the brakes whenever the stroller is
stationary.
WARNING: Never leave the stroller on a sloped surface, with a
child on board, even with the brakes applied.
SLOWING DOWN BRAKE
WARNING: The intended use of the slowing down brake is to slow
down the speed of the stroller. Never use the slowing down brake
as a safety brake.
22. To slow down the speed of the stroller, operate the brake lever
located on the handle (diagram 22).
FRONT SWIVEL WHEEL
The stroller has a fixed/swivel front wheel.
It is recommended to use the fix wheel when using the stroller
on particularly uneven surfaces. The use of the swivel wheel is
recommended to increase the manoeuvrability of the stroller.
23. To use the front wheel in the swivel mode, push the front lever
in a downward direction with your foot, as shown in diagram 23.
To use the front wheel in the fixed mode, lift the lever with the
foot: the wheel will lock in the straight position independently of
its position.
ADJUSTABLE REAR SUSPENSION
The stroller has an adjustable rear suspension.
24. To adjust the suspension, operate the lever indicated in diag. 24.
By moving the lever inward, the suspension becomes softer (ideal
for use with young children), while by moving the lever outward,
the suspension becomes harder (ideal for older children).
Both suspension units must be adjusted to the same setting when
in use.
HOW TO USE THE CHILD CAR SEAT AND CARRYCOT
WARNING: Please read carefully the instruction booklets on how
to use the carrycot and child car seat.
WARNING: Only the CHICCO child car seats and carrycots featuring
the CLIK CLAK devices can be fitted to the stroller. Before using the
stroller with the carrycot or child car seat fitted to it, always check
that the locking system is locked into the correct position.
The stroller has the Clik Clak system, which allows you to fit the
carrycot or child car seat without using any further locking devices.
The stroller can be fitted with the carrycot or child car seat, both
with or without fabric seat cover fitted to the stroller. To fit and
remove the fabric cover of the stroller, please refer to the paragraph
“How to fit/remove the fabric cover”.
25. The Clik Clak locking system is located on the armrests of the
stroller. First unfasten the fabric cover of the armrests as shown in
diagram 25. It is recommended to raise the central part of the flap
and then release the plastic joints from the openings located on the
armrests. Remove the bumper bar.
26. Operate the buttons on the rear of the armrests (diagram 26 A),
