583951
49
Zoom out
Zoom in
Previous page
1/68
Next page
Notice: Pulling the wiring harness through a panel
hole that has sharp edges may cause damage to the
wire and/or wire insulation. Remove sharp edges
from the panel hole before pulling the wire
through it.
Option A: Roof Wires Directly to Accessory
1. Drill a 3/8 inch to 1/2 inch (10 to 13 mm) hole in
the outer roof panel in the area shown in the
illustration. The hole should only go through the
outer panel. Remove all sharp edges from the
drilled hole.
2. Remove the inside overhead console access
panel/lamp lenses.
3. The accessory harness is coil tied to the
passenger's side of the vehicle at the console
inner bracket.
4. Cut the tape holding the harness coil.
5. As one person watches the roof hole from the
outside for the end of the harness, a second
person from the inside of the vehicle should snake
the harness toward the hole.
6. Pull out the wiring harness being careful to avoid
scraping the insulation on the edge of the hole.
7. Extend the wiring harness to the accessory.
8. Connect the dark green wire to the accessory hot
terminal.
9. Connect the black wire to the accessory ground
terminal.
10. Cover the hole in the roof with a durable sealant
such as silicone rubber sealer.
11. Reinstall the overhead console access panel/lamp
lenses.
15-13
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chevrolet Tahoe Police 2010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chevrolet Tahoe Police 2010 in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info