52
Operation of appliances
?
2) Manual adjustment: some models have this type of
adjustment, which is done by raising the mattress and
placing the adjustment wedge at the desired height.
A small safety strap ensures that the wedge stays in
place. (Do not forget the safety strap: we decline all
responsibility for accidents that might happen in case
this strap has not been properly positioned)..
Electrically controlled central bed
Bedding on certain models is a central bed.. This
bed is electrically controlled and has the following
characteristics:
1) From a safety point of view:
- The bed is held at the top by a safety belt-type “blocker”
which should be released to allow lowering the bed;
- A key-activated system must be turned on for the bed
to function;
Be sure you have taken these two steps before lowering
the bed.
- Upper and lower safety features have been installed to
allow sufficient space above and below the bed.
2) From an operationally point of view:
Two sleeping positions:
Be sure that: a) the table,
bench and cushions are properly
positioned and do not block
installation of the bed; b) the
safety net for the bed has been
detached from the roof.
1) Intermediate:
-
Bed lowered in two stages halfway «automatically» simply
by pressing the control button. In this intermediate position
it is of course possible to reach the bed via a ladder as well
as in the lower position using the dining table.
2) Low:
The low position can be accessed from the intermediate
position by:
- Keeping your finger on the control button until the
travel end stop. This position enables access to the bed
without a ladder, but it is no longer possible to use the
dinette area for another bed. The return to day-time
position (bed in the roof) takes place in 3 phases, the
first two being automatic simply by pressing the control
button and the final one, until the engine stops, by
pressing constantly on the control button. This is contrary
to the maneuver for descending the bed.
NB : Maximum allowed mass on the moveable bed
is: electrically controlled central bed = 140cm:
230 kg and manually controlled central bed = 120cm:
150 kg. A lever to activate the system in case of total
electrical failure is supplied with the bed.
PLEASE NOTE0
- The bed should not be covered with sheets and blankets
when manipulated.
- Use of the fold-down bed, between 1 m from the ground
and the programmed intermediate position, without
adapted access is not permitted
.
