815485

Charnwood SLX 45 MKII - Multi fuel Manual

7
Zoom out
Zoom in
Previous page
1/20
Next page
maximum and wait until flames appear above the fuel bed before
opening the doors.
Burning coal will produce more soot deposits than other fuels,
especially if the fire is run at low levels for long periods. It is
therefore vital to clean the throat plate regularly, daily cleaning is
recommended.
MAINTENANCE
Cleaning
To clean
the surfaces simply wipe over with a dry cloth. Abrasive pads and
scouring cleaners must not be used as these will damage the finish.
Care should be taken not to knock the enamel with hard objects as it
will chip.
Cleaning the Glass
The glass in the doors is a special ceramic glass which is able to
withstand high temperatures. Before cleaning the glass open the
doors and allow them to cool. Clean the glass using a damp cloth
and then wiping over with a dry cloth. Any stubborn deposits on the
glass may be removed with a proprietary stove glass cleaner or
ceramic hob cleaner. Some deposits on the glass may be burnt off
simply by running the fire at a fast rate for a few minutes. Do not
use abrasive cleaners or pads as these can scratch the surface which
will weaken the glass and cause premature failure. Aerosol spray
cleaners should not be used near the appliance whilst it is under fire.
When not in use
If the fire is going to be out of use for a long period, (for instance in
the summer,) then to prevent condensation, and hence corrosion,
the thermostat should be left at the maximum setting and the main
doors left ajar. It is also advisable to sweep the chimney and clean
out the fire. Spraying the inside of the doors and firebox with a light
oil, such as WD40, will also help to keep all internal parts working
well.
After long periods where the fire has been out of use, the chimney
and appliance flueways should be cleaned before lighting.
Door Seals
For the fire to operate correctly it is important that the door seals
are in good condition. Check that they do not become worn or
frayed and replace them when necessary.
Please also note that when burning coal, some
blackening of the glass may occur.
The appliance is finished in silicone paint or vitreous enamel.
Servicing
It is recommended that the fire is serviced once a year to keep it in
first class working order. After cleaning out the firebox thoroughly,
check that all internal parts are in good working order
CHIMNEY SWEEPING
The chimney should be swept at least twice a year. In most
installations it will be possible to sweep the chimney through the
appliance.
First remove the front firebars and the throat plate. Then sweep the
chimney ensuring that soot is removed from all horizontal surfaces
after sweeping.
In situations where it is not possible to sweep through the appliance
the installer will have provided alternative means, such as a soot
door. After sweeping the chimney the appliance flue outlet and the
flue pipe connecting the appliance to the chimney must be cleaned
with a flue brush.
After clearing any soot from within the fire, replace the throat plate
and the front firebars.
Different types of sweep’s brushes are available to suit different
flueways. For standard brick chimneys a wire centre sweep’s brush
fitted with a guide wheel is recommended. For prefabricated
insulated chimneys the manufacturers instructions with regard to
sweeping should be consulted.
, replacing any
parts that are beginning to show signs of wear. Check that the door
seals are in good condition and that the door seals correctly. A
servicing guide is available on request. Repairs or modifications may
only be carried out by the Manufacturer or their approved agents.
Use only genuine Charnwood replacement parts.
Where the chimney previously served an open fire, it is possible
that the higher flue gas temperature from a stove may loosen soot
deposits with the consequent risk of flue blockage. It is therefore
recommended that the chimney be swept a second time within a
month of regular use after installation.
7
®
charnwood
OPERATING INSTRUCTIONS SLX45
MU LT I-F UEL
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood SLX 45 MKII - Multi fuel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood SLX 45 MKII - Multi fuel in the language / languages: English as an attachment in your email.

The manual is 2.15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info