Manual Charnwood Island II ct (page 5 of 16) (English)

632323

Zoom out

Zoom in

1/16

between allowing the primary combustion air to come up through

the grate and through the fuel bed.

2) In the closed position the grate bars are horizontal, allowing the

combustion air to come round the sides of the grate and over the top

of it. When in the closed position ash is able to build up on the grate

as is necessary for effective wood burning.

Movement of the grate from one position to the other is effected

using the tool supplied as shown in Fig. 2. The grate is put into the

open position by moving the tool up until the handle is in the 1

o'clock position. The grate is put into the closed position by moving

the tool down until the handle is in the 5 o'clock position. To riddle

the appliance the tool should be moved between the 1 o'clock and 3

o'clock positions several times.

When burning

wood the ash should be allowed to build up and riddling should only

be carried out

Before lighting the stove for the first time the soapstone top must be

rubbed with cooking oil. Dip a paper towel or soft cloth into some

cooking oil and rub evenly into the whole flat surface of the

Soapstone and allow to dry before lighting. When lighting for the first

time, heat should be applied gradually. This is achieved by lighting a

small fire initially, then gradually building it up as shown in the next

section.

Light the Stove using dry kindling wood and paper or fire lighters. Set

the grate into the closed position. Place the paper, or fire lighters,

and kindling on the grate and cover with a few small dry logs. Open

the air control fully (see Fig. 1). Light the paper or fire lighters. The

After riddling, the grate should be put

back into the open or closed position as required.

when the ash begins to cover the slots in the rear

fireplate.

SOAPSTONE PREPARATION

LIGHTING

door may be left cracked open for a few minutes to assist the

combustion and heat up the firebox more quickly. When the kindling

wood is well alight add about 3 small logs, close the doors but leave

the air control fully open. When the flames are established around

these logs, then load with logs up to the level of the air holes in the

back firebricks. Maintain the air control at maximum at this stage.

Once the fire is up to temperature the airwash system will begin to

work, so allow the fire to become hot before adjusting the air

controls to the required setting. During the lighting period, do not

leave the stove unattended.

On initial lighting, the stove may smoke and give off an odour as the

silicon paint with which the firebox is painted reacts to the heat. This

is normal and will cease after a short time, but meanwhile the room

should be kept well ventilated.

At first only light a small fire and burn it slowly for two hours to allow

any residual moisture in the bricks to evaporate.

When relighting the stove, riddle slightly and then empty the ashpan.

The fire is controlled by the single air control knob shown in Fig. 1.

Pull the knob out to make the fire burn faster, push it in to make the

fire burn slower.

This unique QuattroFlow air control* provides carefully balanced

primary, secondary, tertiary and bypass air to enable optimum

burning conditions without the need to fiddle with multiple controls.

Keep the firebox filled up to the level of the air holes in the back

firebrick, but do not overfill to prevent fuel from spilling over the top

of the front fire bar. Logs should be evenly distributed, filling the

firebed to give the most pleasing flame pattern. The air control must

be fully opened after refuelling until the flames are established above

the fire. It is best to refuel on to a hot bed of ash. If at this point the

fire starts to die, the doors must be cracked open until the fire is

revived in order that smoke may not be produced. If the fire has

started to die down before refuelling, then more kindling wood must

be added, the air control opened fully and the door cracked open to

re-establish the firebed adding larger logs.

Care should be taken especially when burning wood that fuel does

CONTROLLING THE FIRE

REFUELLING

For correct firing we recommend the use of a stove pipe

thermometer which may be purchased from your supplier or from

ourselves.

before

*Patent No.2389414

Open Position

Fig. 2. Multifuel Grate

Closed Positio

Riddle

OPERATING INSTRUCTIONS

charnwood

I S L A N D

IIct

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Island II ct in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Island II ct

Charnwood Island II ct User Manual - Dutch - 14 pages

Charnwood Island II ct User Manual - French - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Island II ct Manual

Product: