815481

Charnwood ISLAND II - BP Manual

6
Zoom out
Zoom in
Previous page
1/24
Next page
6
®
OPERATING INSTRUCTIONS
times. When burning wood the ash should be allowed to build up
and riddling should only be carried out once or twice a week.
Fig.1 Operating the multi grate
RIDDLING
When burning wood, ash should be allowed to build up and only
riddled when the ash begins to cover the rear fireplate. The fire
should be riddled with the door shut (see Fig.2). Place the operating
tool onto the riddling lever and rotate between the open and closed
positions several times. Too much riddling can result in emptying
unburnt fuel into the ashpan and should therefore be avoided. After
riddling, the grate should be put back into the closed position for
burning wood.
Fig.2 Riddling tool
OPERATING TOOL HOLDER
When not in use the operating tool can be stored on the shelf
underneath the stove.
LIGHTING
On initial lighting, the stove may smoke and give off an odour as the
silicon paint with which the firebox is painted reacts to the heat. This
is normal and will cease after a short time, but meanwhile the room
should be kept well ventilated.
At first only light a small fire and burn it slowly for two hours to allow
any residual moisture in the chimney to evaporate.
Light the stove using dry kindling wood and paper or fire lighters.
Put the paper, or fire lighters, and kindling in the firebox and cover
with a few small dry logs. Open the air control fully (see Fig. 3).
Light the paper or fire lighters. The door may be left cracked open
for a few minutes to assist the combustion and heat up the firebox
more quickly. When the kindling wood is well alight add a few more
small logs, close the door but leave the air control fully open. When
the flames are established around these logs, load the stove with the
required fuel load. Maintain the air control at maximum at this stage.
Once the fire is up to temperature the airwash system will begin to
work, so allow the fire to become hot before adjusting the air control
to the required setting. During the lighting period, do not leave the
stove unattended. Do not leave the door open except as directed
above to avoid excessive smoke.
When relighting the stove, leave the ash on the base if burning
wood, unless it is becoming too deep, in which case some of it may
be removed.
CONTROLLING THE FIRE
The rate of burning and hence the output is controlled by the air
control (see Fig.3).
Fig. 3 Stove controls
Identification
Plate, lift to view
Riddler Knob
Turn the door
handle clockwise
to open, and anti-
clockwise
to close.
AIR CONTROL
Pull out to open, push in
to close.
1. Low Output
2. Nominal
3. High Output
4. Boost
4321
Fuel Selection Slider
Pull out - Solid Fuel
Push in - Wood Logs
Wood
Solid fuel
Wood
Solid fuel
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood ISLAND II - BP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood ISLAND II - BP in the language / languages: English as an attachment in your email.

The manual is 1.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info