Manual Charnwood Island I (page 7 of 20) (English)

632320

Zoom out

Zoom in

1/20

(see 3), the front firebar.

Different types of sweep’s brushes are available to suit different

flueways. For standard brick chimneys a wire centre sweep’s brush

fitted with a guide wheel is recommended. For prefabricated

insulated chimneys the manufacturers instructions with regard to

sweeping should be consulted.

Check that:

a) the air inlet at the rear of the stove is not obstructed in any way,

b) chimneys and flueways are clear,

c) a suitable fuel is being used,

d) there is an adequate air supply into the room,

e) an extractor fan is not fitted in the same room as the stove,

f) there is sufficient draw in the chimney, (once the chimney is warm a

draught reading of at least 0.10 inches (2.5mm) water gauge (25 Pa)

should be obtained).

Keeping the glass clean requires a certain amount of experimentation

due to the differences in the draw of different chimneys. The

following points should be noted and with a little care should enable

the glass to be kept clean in most situations:

a) The airwash relies on a supply of heated air to keep the glass clean.

Therefore, when lighting the stove, allow the firebed to become well

established before closing the air control. This also applies when re-

fuelling the stove.

b) When re-fuelling, keep the fuel as far back from the front firebar

Fig. side fireplates, and

TROUBLE SHOOTING

Fire Will Not Burn

Blackening of Door Glass

as possible, do not try to fit too much fuel into the firebox.

c) Wet wood or logs overhanging the front firebars will cause the

glass to blacken.

d) There is a bypass slide that can be adjusted to suit the particular

installation. This allows a small amount of airwash air to enter the

stove even when the air control is closed. This can be adjusted to help

with keeping the glass clean when the fire is slumbering.

It is always more difficult to keep the glass clean when running the

stove very slowly for long periods.

Check that all flue connections and the blanking plate are well sealed.

It is also important that the chimney draw is sufficient (when the

chimney is warm a draught reading of at least 0.10 inches water

gauge (25 Pa) should be obtained), and that it is not affected by

down-draught.

Occasionally some blackening of the glass may occur below the level

of the front firebars. This will not obscure the view of the fire or

affect its performance.

The most common cause of fume emission is flueway or chimney

blockage. For your own safety these must be kept clean.

Your installer should have fitted a CO alarm in the same room as the

appliance. If the alarm sounds unexpectedly, follow the instructions

given under “Warning Note” above.

Check that:

a) The doors are tightly closed.

b) The air control is pushed in.

Fume Emission

Fire blazing out of control

Warning Note: Properly installed and operated this appliance will

not emit fumes. Occasional fume from de-ashing and re-fuelling

may occur. Persistent fume emission is potentially dangerous and

must not be tolerated. If fume emission does persist, then the

following immediate actions should be taken:

a) Open doors and windows to ventilate the room, and then leave

then premises.

b) Let the fire go out.

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to re-light the fire until cause of fume has been

identified, if necessary seek professional advice.

CO Alarm

Lift throat plate at front,

then pull forward and

swing down.

Fig. 3. Throat Plate

OPERATING INSTRUCTIONS

charnwood

I S L A N D

IIIII

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Island I in the language / languages: English as an attachment in your email.

The manual is 0,96 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Island I

Charnwood Island I User Manual - Dutch - 19 pages

Charnwood Island I User Manual - French - 22 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Island I Manual

Product: