815480

Charnwood ISLAND I - AP Manual

8
Zoom out
Zoom in
Previous page
1/24
Next page
8
®
OPERATING INSTRUCTIONS
Cleaning the Glass
Most deposits on the glass may be burnt off simply by running the fire
at a fast rate for a few minutes. If it becomes necessary to clean the
glass then open the door and allow it to cool. Clean the glass using
a damp cloth and then wiping over with a dry cloth. Any stubborn
deposits on the glass may be removed with a proprietary stove glass
cleaner or ceramic hob cleaner. Do not use abrasive cleaners or pads
as these can scratch the surface which will weaken the glass and cause
premature failure
When Not in Use
If the fire is going to be out of use for a long period (for instance in
the summer) then to prevent condensation, and hence corrosion, the
air control should be left fully open and the fire door left ajar. It Is also
advisable to sweep the chimney and clean out the fire. Spraying the
inside of the door and firebox with a light oil, such as WD40, will also
help to keep all internal parts working well. After long periods where
the fire has been out of use, the chimney and appliance flueways
should be cleaned before lighting.
Door Seals
For the fire to operate correctly it is important that the door seals
are in good condition. Check that they do not become worn or
frayed and replace them when necessary.
Servicing
It is recommended that the fire is serviced once a year to keep it in
first class working order. After cleaning out the firebox thoroughly,
check that all internal parts are in good working order, replacing
any parts that are beginning to show signs of wear. Check that the
door seals are in good condition and that the doors seal correctly. A
servicing guide is available on request. Repairs or modifications may
only be carried out by the Manufacturer or their approved agents.
Use only genuine Charnwood replacement parts.
THROAT PLATE AND FLUEWAY CLEANING
It is important that the throat plate and all the stove flueways are kept
clean in order to prevent potentially dangerous fume emission. They
should be cleaned at least monthly, and more frequently if necessary.
It is necessary to let the fire out to carry out these operations.
To remove the throat plate, first remove the fuel retainer (item ‘e’
page 4) and one side fire plate to allow enough room so that the
throat plate clears the sides of the fire box when removed.
Slide the throat plate forwards so that it clears the back brick, then
slide it either right or left so that the opposite side clears the top
of the remaining side brick and can be gently lowered. Any sooty
deposits should then be swept from the throat plate and into the fire.
To return the throat plate to its correct position- At an angle, insert
the throat plate so that it sits on top of either the right or left side
brick. Raise the opposite side and slide so that the throat plate is
central and supported by the side bricks. Slide back so that the throat
plate rests neatly on the top of the back bricks. Refit the remaining
side plate.
The Island II - BP throat plate consists of two firebricks which rest
on the central bracket (part BP077) and the two side bricks. The
central bracket rests on top of the rear bricks and slots into the hole
at the top face of the stove between the airwash tubes. To lower the
throat plate bricks, push a brick up towards the topmost corner of
the stove, and lower down diagonally.
The Island II -BP also has an upper baffle plate that rests centrally on
top of the air wash tubes and locates into the hook at the top of the
front of the firebox.
Fig.5 Throat Plate Location
CHIMNEY SWEEPING
Where the chimney previously served an open fire, it is possible
that the higher flue gas temperature from a stove may loosen soot
deposits with the consequent risk of flue blockage. It is therefore
recommended that the chimney be swept a second time within a
month of regular use after installation.
The chimney should be swept at least twice a year. Where the top
outlet or vertical rear flue connector is used it will generally be
possible to sweep the chimney through the appliance.
First remove the fuel retainer and the throat plate. Then sweep the
chimney ensuring that soot is removed from all horizontal surfaces
after sweeping.
Throat plate
Upper throat plate
(Island II - BP only)
Side view
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood ISLAND I - AP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood ISLAND I - AP in the language / languages: English as an attachment in your email.

The manual is 1.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info