Manual Charnwood Cove 3 (page 6 of 20) (English)

632313

Zoom out

Zoom in

1/20

the grate bars. The ashpan is handled using the Door Opening tool

provided. Ensure that the tongue of the ashpan is protruding through

the slot in the top of the tool before lifting (See Fig.3). Care should

be taken to ensure that ash is cool before emptying it into plastic

liners or bins.

To make ash removal easier there is a special Charnwood ash carrier

available. This may be purchased from your supplier or, in case of

difficulty, from ourselves.

The grate should be kept in the closed position and should not be

riddled until the ash becomes so deep that it begins to block the

passage of air into the firebox at the sides or back of the grate. When

this is the case do not remove all of the ash using the riddling

mechanism but keep a layer about half an inch thick as this enables

the wood to burn more effectively. When lighting the fire a few small

dry logs with a good amount of kindling will help to get the fire up to

temperature quickly.

The stove is finished with a high temperature paint which will

withstand the temperatures encountered in normal use. This may be

cleaned with a damp lint-free cloth when the stove is cold. Should re-

painting become necessary then special high temperature paints are

available from your supplier or from Charnwood.

The glass in the door is a special ceramic glass which is able to

withstand high temperatures. Before cleaning the glass open the door

Special Points when Burning Wood

Cleaning

Cleaning the Glass

MAINTENANCE

and allow it to cool. Clean the glass using a damp cloth and then wipe

over with a dry cloth. Any stubborn deposits on the glass may be

removed with a proprietary stove glass cleaner or ceramic hob

cleaner. Some deposits on the glass may be burnt off simply by

running the fire at a fast rate for a few minutes. Do not use abrasive

cleaners or pads as these can scratch the surface which will weaken

the glass and cause premature failure. Aerosol spray cleaners should

not be used near the appliance whilst it is under fire.

If the fire is going to be out of use for a long period (for instance in

the summer) then to prevent condensation, and hence corrosion, the

air control should be left fully open and the fire door left ajar. It is

also advisable to sweep the chimney and clean out the fire. Spraying

the inside of the door and firebox with a light oil, such as WD40, will

also help to keep all internal parts working well.

After long periods where the fire has been out of use, the chimney

and appliance flueways should be cleaned before lighting.

For the fire to operate correctly it is important that the door seals

are in good condition. Check that they do not become worn or

frayed and replace them when necessary.

It is recommended that the fire is serviced once a year to keep it in

first class working order. After cleaning out the firebox thoroughly,

check that all internal parts are in good working order, replacing any

parts that are beginning to show signs of wear. Check that the door

seals are in good condition and that the door seals correctly. A

servicing guide is available on request. Repairs or modifications may

only be carried out by the Manufacturer or their approved agents.

Use only genuine Charnwood replacement parts.

It is important that the throat plate and all the stove flueways are kept

clean. They should be checked approximately once a week, by

looking up into the firebox for signs of soot or fly-ash on the throat

plate and at the sides of the firebox. If there are signs of a build up of

soot or fly-ash deposits then the fire must be let out in order to clean

the throat plate and flueways.

Before attempting to clean the throat plate and flueways ensure that

the fire is cold. Wear suitable gloves to prevent irritation from soot

deposits. To remove the throat plate lift the front edge up, pull the

When Not in Use

Door Seals

Servicing

THROAT PLATE AND

FLUEWAY CLEANING

Lift throat plate at front,

then pull forward and

swing down. For Cove 1

Remove tubes from front

supports before swinging

Throat plate down.

Fig. 4. Throat Plate

charnwood

OPERATING INSTRUCTIONS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Cove 3 in the language / languages: English as an attachment in your email.

The manual is 1,27 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Charnwood Cove 3

Charnwood Cove 3 User Manual - Dutch - 22 pages

Charnwood Cove 3 User Manual - French - 20 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Cove 3 Manual

Product: