815484

Charnwood Country 6-8-12 Manual

9
Zoom out
Zoom in
Previous page
1/16
Next page
stove by at least 300mm (12 inches) and to the sides of the stove by
at least 150mm (6 inches). If in doubt as to the positioning of the
stove expert advice should be sought either from the supplier or the
local building inspector.
The fireplace must allow good circulation of air around the appliance
to ensure that maximum heat is transferred to the room and also to
prevent the fireplace from overheating. A gap of 150mm (6 inches)
each side and 300mm (12 inches) above the appliance should give
sufficient air circulation. If a wooden mantelpiece or beam is used in
the fireplace it should be a minimum of 460mm (18 inches), and
preferably 600mm (24 inches) from the appliance. In some situations
it may be necessary to shield the beam or mantelpiece to protect it.
There are several ways of connecting the stove to the flue. These are
illustrated in Figs. 5 to 8.
If the optional vertical rear flue connector is used then the chimney
may be swept through the appliance, except in the case of a Country
6 fitted with a boiler.
Horizontal lengths of flue must be kept to a minimum and should not
be more than 150mm (6 inches) long. The sealing face of the flue
collar must be coated with fire cement before fixing to the body of
the stove using the two screws provided. The blanking plate must be
removed, sealed with fire cement and refitted, care being taken to
ensure that the fold on the blanking plate is in line with the lugs on
the firebox as shown in Fig. 9. Ensure that the clamping plate does
not prevent the throat plate from seating correctly. All flue
connections must be well sealed.
It is possible to pass a 16 inch diameter sweeps brush through the
appliance but in most back outlet installations it will be necessary to
have a soot door to enable the chimney to be swept. The optional
vertical rear flue connector does allow the chimney to be swept
through the stove.
Soot doors may either be in the actual brickwork of the chimney or
in the register plate. Various positions of soot doors are shown in
Figs. 5 to 8.
CONNECTIONS TO FLUES
SOOT DOORS
9
®
INSTALLATION INSTRUCTIONS
Fig. 5. Vertical Register Plate With Bricked Up Fireplace
Of Chimney
Soot Door
In Side or Rear
Register Plate
Fig. 7. Horizontal Register Plate With Top Flue Connection
Alternative Soot
Door Positions
Register Plate
With Soot Door
Fig. 6. Horizontal Register Plate With Rear Flue Connection
Soot Door
Alternative
Positions
Register Plate
With Soot Door
Fig. 8. Horizontal Register Plate With Optional
Vertical Rear Flue Connector
Register Plate
With Soot Door
Alternative Soot
Door Positions
98
186
charnwood
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Country 6-8-12 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Country 6-8-12 in the language / languages: English as an attachment in your email.

The manual is 0.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info