Manual Charnwood Country 4 Blu (page 9 of 20) (English)

815475

Zoom out

Zoom in

1/20

UNPACKING THE STOVE

The stove arrives fixed its pallet facing up. There must be adequate

facilities for unloading and manoeuvring into position The wrapping

is first removed, then the stove released from the pallet by removing

the screws from the base. The stove may now be moved to its final

position. The pallet is intended to be cut up and used for kindling fuel.

HEALTH AND SAFETY PRECAUTIONS

Please take care when installing the stove that the requirements of

the Health and Safety at Work Act 1974 are met.

Some types of fire cement are caustic and should not be allowed to

come into contact with the skin. In case of contact wash with plenty

of water.

If there is a possibility of disturbing any asbestos in the course of

installation then please use appropriate protective equipment.

Ideally there should not be an extractor fan fitted in the same room

as the appliance. If this situation is unavoidable then specialist advice

should be taken to ensure that the extractor fan does not cause

the appliance to emit fumes into the room. An additional air supply

correctly positioned may be necessary. It is essential to carry out a

spillage test to ensure that the appliance can operate safely when the

extractor fan is operating.

There must be an adequate air supply into the room in which the

appliance is installed to provide combustion air. The combustion air

supply must be via a permanently open vent. The requirement for

minimum free area is partly dependent on the design air permeability

of the house. In older properties the air permeability will be above

5.0m³/(h.m²), but in some modern properties it may be less.

The vent must be positioned such that it is not liable to blockage.

Minimium areas are given in the following table:

This stove is capable of intermittent operation, and is not suitable for

use in a shared flue system.

In addition to these instructions the requirements of BS.8303 and

BSEN 15287-1:2007 must be fulfilled. Local Authority Bylaws

and Building Regulations, including those referring to national and

European Standards, regarding the installation of Solid Fuel burning

appliances, flues and chimneys must also be observed.

CO ALARMS

Building regulations require that whenever a new or replacement

fixed solid fuel or wood/biomass appliance is installed in a dwelling

a carbon monoxide alarm must be fitted in the same room as

the appliance. Further guidance on the installation of the carbon

monoxide alarm is available in BS EN 50292:2002 and from the

alarm manufacturer’s instructions. Provision of an alarm must not

be considered a substitute for either installing the appliance correctly

or ensuring regular servicing and maintenance of the appliance and

chimney system.

SPECIFICATION

CHIMNEY

In order for the appliance to perform satisfactorily the chimney

height must not be less than 4 metres measured vertically from the

outlet of the stove to the top of the chimney. The internal dimensions

of the chimney should preferably be 150-200 mm (6”- 8”) either

square or round and MUST NOT BE LESS THAN 125 mm (5”)

If an existing chimney is to be used it must be swept and checked,

it must be in good condition, free from cracks and blockages, and

SPECIFICATION COUNTRY 4 BLU

Fuel Wood logs

Rated Heat Output kW (BTU/hr) 5.0

Stove Weight kg (Packed) 60kg

Flue Temperature °C 221

Minimum Flue Draught 12Pa

Flue gas Mass Flow g/s 4.5

Hearth Temperature >100

Minimum distance from

combustibles mm SIDE BACK

Without optional heat shield 480 550

With optional heat shield 480 150

The outputs in the table are based on a 45 minute re-fuelling cycle

burning seasoned hardwood logs. All tests are carried out in accordance

with BSEN 13240.

AIR PERMEABILITY

m3/(h.m2)

MINIMUM VENT AREA

cm2(in2)

COUNTRY 4 BLU

>5.0 No requirement

<5.0 27.5 (4.3)

INSTALLATION INSTRUCTIONS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Country 4 Blu in the language / languages: English as an attachment in your email.

The manual is 1.7 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Country 4 Blu Manual

Product: