815475
5
Zoom out
Zoom in
Previous page
1/20
Next page
5
®
OPERATING INSTRUCTIONS
Congratulations on becoming the owner of a Charnwood Country
4 Blu Stove. Your stove has been approved in smoke control areas
to burn wood logs if it is used in accordance with these instructions.
It is very important that you read and understand these instructions
before using the stove.
Before lighting the stove check with the installer that the work and
checks described in the Installation Instructions have been carried
out correctly and that the chimney has been swept, is sound and free
from any obstructions. The stove is not suitable for use in a shared
flue system.
If you are using your stove to burn wood logs in a smoke controlled
area, then the provided Defra Stop MUST be fitted and the
instructions on lighting and refuelling MUST be followed. This stove
will not produce significant smoke if well seasoned logs of less than
20% moisture content are burnt and these instructions are adhered
to. Burning wet (>20% moisture content) wood and operating the
stove in an irresponsible manner may produce smoke which is illegal
in smoke controlled areas.
Remember that the stove will be hot and that it is made from hard
materials – ensure that you have good balance before operating the
fire. Always use the provided operating tool and gloves.
Do not use an aerosol spray on or near the stove when it is alight.
There is a risk of explosion or flash ignition of the spray.
When using the stove in situations where children, aged and/or infirm
persons are present a fireguard must be used to prevent accidental
contact with the stove. The fireguard should be manufactured in
accordance with BS 8423:2002.
The stove is suitable for intermittent operation.
FUEL
This stove has been designated to burn wood. Only dry well
seasoned wood should be burnt on this appliance as burning wet
unseasoned wood will give rise to heavy tar deposits in the stove, on
the glass and within the chimney. For the same reason hard woods
(such as Ash, Beech and Oak) are better than soft woods (such as
Pine and Spruce). Burning wet unseasoned wood will also result in
considerably reduced outputs. The wood should be cut and split and
then left to season in a well ventilated dry place for at least one year
but preferably two years before use.
Approximate suitable log sizes are:
225mm(10in) long and 75mm (3in) diameter
Log moisture content of less than 20% is recommended.
PETROLEUM COKE IS NOT SUITABLE FOR USE ON THIS
APPLIANCE. ITS USE WILL INVALIDATE THE GUARANTEE.
This stove is not designed to burn household waste.
LIGHTING
On initial lighting, the stove may smoke and give off an odour as the
silicon paint with which the firebox is painted reacts to the heat. This
is normal and will cease after a short time, but meanwhile the room
should be kept well ventilated.
At first only light a small fire and burn it slowly for two hours to allow
any residual moisture in the chimney to evaporate.
Light the stove using dry kindling wood and paper or fire lighters.
Put the paper, or fire lighters, and kindling in the firebox and cover
with a few small dry logs. Open the air controls – the primary air
control in the door and the airwash control - fully (see Fig. 1) Light
the paper or fire lighters. The door may be left cracked open for a
few minutes to assist the combustion and heat up the firebox more
quickly. When the kindling wood is well alight add a few more small
logs, close the door but leave the air control fully open. When the
flames are established around these logs, load the stove with the
required fuel load. Maintain the air control at maximum at this stage.
Once the fire is up to temperature the airwash system will begin to
work, so allow the fire to become hot before adjusting the air control
to the required setting. During the lighting period, do not leave the
stove unattended. Do not leave the door open except as directed
above to avoid excessive smoke.
When relighting the stove, leave the ash on the base if burning
wood, unless it is becoming too deep, in which case some of it may
be removed.
CONTROLLING THE FIRE
The rate of burning and hence the output is controlled by the spin
wheel and the airwash control (see Fig. 1).
The spin wheel should only be used when lighting or when rapid
burning is required. It should not be left fully open for long periods as
this can cause over-firing. For low burning it should be closed.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Country 4 Blu at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Country 4 Blu in the language / languages: English as an attachment in your email.

The manual is 1.7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info