815483
15
Zoom out
Zoom in
Previous page
1/20
Next page
®
COUNTRY 4 DIMENSIONS (MM)
15
®
INSTALLATION INSTRUCTIONS
SOOT DOORS
THERMOSTAT
PRE LIGHTING CHECK
It is possible to pass a 16 inch diameter sweeps brush through
the appliance but in most back outlet installations it will be
necessary to have a soot door to enable the chimney to be
swept. This may either be in the actual brickwork of the
chimney or in the register plate. Various types and positions of
soot doors are shown in figures 8 to 11.
Before lighting the fire, check the cold setting distance of the
thermostat. This is fitted under the firebox. Removing the ash
lip will give easier access.
With the control knob at the minimum setting the flap should
be just closed as shown in Fig. 13. To adjust the distance slacken
the locking nut and adjust as necessary. When set correctly re-
tighten the locking nut. Ensure that the flap opens and closes
freely as the knob is turned, and that the opening is completely
covered when the flap is closed.
Before initial lighting the following points should be checked:
1. The bottom grate bars must all be fitted and should move
freely and easily when the riddling mechanism is operated.
2. The plates round the sides and back of the grate must be in
position and sitting correctly.
3. The throat plate must be fitted in the roof of the appliance
and should be checked to ensure that it has not become
dislodged in transit. The method of location and positioning of
the throat plate is shown in Fig. 3.
On completion of the installation and after allowing a suitable
period of time for the fire cement and mortar to dry out, the
stove should be lit and checked to ensure that smoke and
fumes are taken from the appliance up the chimney and
emitted safely. Also check all joints and seals for soundness.
The central heating pump should be adjusted to give the
correct water flow against the circuit resistance and the
system should be correctly balanced.
On completion of the installation and commissioning, please
leave the operating instructions with the customer and advise
on the use of the appliance and any controls on the system.
COMMISSIONING
Blanking Plate
Blanking Plate Clamping Plate
with fold horizontal
Back of the Stove
Clamping plate finishes
flush with inside face of
firebox top and bottom.
with fire cement
Seal Blanking Plate
Fig. 12 Flue Blanking Plate
Thermostat Flap
Locking Nut
Fig. 13. Thermostat Setting
Flap just closed with
knob on minimum
charnwood
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Country 16b - Multi-fuel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Country 16b - Multi-fuel in the language / languages: English as an attachment in your email.

The manual is 1.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info