815483
6
Zoom out
Zoom in
Previous page
1/20
Next page
allowed to build up and generally weekly riddling will be
sufficient. The fire should be riddled with the doors shut (see
Fig. 2). Place the tool onto the riddling lever and rotate
between the 1 o'clock and 3 o'clock positions several times.
Too much riddling can result in emptying unburnt fuel into the
ashpan and should therefore be avoided. If any clinker forms it
should be removed from the firebed. After riddling, the grate
should be put back into the solid fuel or wood position as
required (the tool should be in the 1 o'clock position for solid
fuel or in the 5 o'clock position for wood).
Keep the firebox well filled but do not overfill to prevent fuel
from spilling over the top of the front fire bars.
Take especial care that logs do not project over the front fire
bars or damage to the glass may be caused when the doors
are closed. It can also cause the glass to blacken. Maximum
filling height is such that fuel cannot fall from the fire when the
doors are opened. Liquid fuels are not to be used on this
stove.
The ashpans should be emptied regularly before they become
too full. Never allow the ash to accumulate in the ashpans so
that it comes in contact with the underside of the grate as this
will seriously damage the grate bars. The ashpans are handled
using the tool provided. Care should be taken to ensure that
ash is cool before emptying it into plastic liners or bins.
To make ash removal easier there is a special Charnwood ash
carrier available. This may be purchased from your supplier or,
in case of difficulty, directly from Charnwood.
When loading the stove take care not to smother the fire.
Instead, fill the firebox in two stages, waiting between each
stage for the flames to appear above the fire.
After a period of slumbering always turn the air control up to
maximum and wait until flames appear above the fuel bed
before opening the doors.
REFUELLING
ASH CLEARANCE
SPECIAL POINTS WHEN BURNING COAL
Burning coal will produce more soot deposits than other
fuels, especially if the fire is run at low levels for long periods.
It is therefore vital to clean the throat plate regularly, weekly
cleaning is recommended. Please also note that when burning
coal, some blackening of the glass may occur.
Never fully close the airwash control when burning coal.
The grate should be kept in the wood burning position and
should not be riddled until the ash becomes so deep that it
begins to block the passage of air into the firebox at the side
of the grate. When this is the case do not remove all of the
ash using the riddling mechanism but keep a layer about half
an inch thick as this enables the wood to burn more
effectively. When burning wood or peat use the airwash
control in the same way as described (see "Controlling the
Fire").
For overnight burning the fire doors must be closed.
When burning solid fuel the ashpans should be emptied and
the fire riddled. If the fire is very low then it may be necessary
to add a little fuel and turn the thermostat control up to
maximum for a brief period until the fire is burning brightly
before filling with fuel. When the new fuel has ignited, the
thermostat control should be turned down to the required
setting and the airwash control moved to a low setting. If the
central heating pump is off overnight then the thermostat
may be left at the same setting for both day and night
operation. If the central heating pump is on overnight then set
the thermostat control to give the required level of heating.
Some experimentation will be necessary to find the settings
most suitable for the particular fuel used and the draw on the
chimney.
To revive the fire, empty the ashpans, riddle, and open the air
controls to maximum. When the fire is burning well, load on
more fuel as necessary and move the air controls to the
SPECIAL POINTS WHEN BURNING
WOOD AND PEAT
OVERNIGHT BURNING
6
®
OPERATING INSTRUCTIONS
charnwood
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Charnwood Country 16b - Multi-fuel at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Country 16b - Multi-fuel in the language / languages: English as an attachment in your email.

The manual is 1.25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info