Manual Charnwood Bay BX (page 9 of 20) (English)

815476

Zoom out

Zoom in

1/20

a) Wet or unseasoned wood, or logs overhanging the front fence will

cause the glass to blacken.

b) The airwash relies on a supply of heated air to keep the glass clean,

therefore, when lighting the stove allow the firebed to become well

established before closing the air control. This may also be necessary

when re-fuelling the stove.

c) When re-fuelling keep the fuel as far back from the front fence as

possible, do not try to fit too much fuel into the firebox.

d) Do not completely close the air control.

It is always more difficult to keep the glass clean when running the

stove very slowly for long periods.

If blackening of the glass still occurs check that all flue connections

and the blanking plate are well sealed. It is also important that the

chimney draw is sufficient and that it is not affected by down-draught.

When the chimney is warm a draught reading of at least 1.25 mm

(0.05 in.) water gauge (12Pa) should be obtained. Some blackening

of the glass may occur below the level of the fuel retainer. This will

not obscure the view of the fire or affect its performance.

Fume Emission

Warning Note:

Properly installed and operated this appliance will not emit fumes.

Occasional fumes from de-ashing and re-fuelling may occur.

Persistent fume emission is potentially dangerous and must not be

tolerated. If fume emission does persist, then the following

immediate actions should be taken:

a) Open doors and windows to ventilate the room and then leave

the premises.

b) Let the fire out and safely dispose of the fuel from the

appliance.

c) Check for flue or chimney blockage, and clean if required.

d) Do not attempt to re-light the fire until cause of fuming has

been identified, if necessary seek professional advice.

The most common cause of fume emission is flueway or chimney

blockage. For your own safety these must be kept clean.

Fire blazing out of control

Check that:

a) The door is tightly closed.

b) The air control slider is fully closed.

c) A suitable fuel is being used.

d) Door seals and air slide are intact.

Chimney Fires

If the chimney is thoroughly and regularly swept, chimney fires should

not occur. However, if a chimney fire does occur close the air control,

and tightly close the door of the appliance. This should cause the

chimney fire to go out in which case the controls should be kept

closed until the stove has gone out. The chimney and flueways should

then be cleaned. If the chimney fire does not go out when the above

action is taken then the fire brigade should be called immediately.

After a chimney fire the chimney should be carefully examined for

any damage. Expert advice should be sought if necessary.

CO ALARM

Your installer should have fitted a CO alarm in the same room as the

appliance. If the alarm sounds unexpectedly, follow the instructions

given under “Warning Note” above.

IF YOU NEED FURTHER HELP

If you need further help with your Charnwood then your Installer will

be able to provide the answers to most questions. Your Local

Charnwood Premier Dealer has a great deal of experience and will

also be able to provide helpful advice. Further help is available from

the Charnwood Customer Services department who will be pleased

to give advice, if necessary.

OPERATING INSTRUCTIONS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Charnwood Bay BX in the language / languages: English as an attachment in your email.

The manual is 2.38 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Charnwood Bay BX Manual

Product: