555437
33
Zoom out
Zoom in
Previous page
1/44
Next page
32
Operation
Features
Your garage door opener is equipped with featuresto provide you with greater control over your garage
door operation.
TIMER-TO-CLOSE (TTC) (Not available on all models)
The Timer-to-Close feature automaticallyclosesthe door after a specified time period that can be
adjusted using the door control. DO NOT enable TTC if operating a one-piece door. TTC is to be used
ONLY with sectional doors. Factory default issetto off. The garage door opener will beep and the lights
will flash before closing the door. The TTC feature will deactivate if the garage door encounters an
obstruction twice;or the safetyreversing sensors are incorrectly installed. The garage door will reverse
open and WILL NOT close until the obstructions are clear or the safetyreversing sensors are correctly
installed. When the obstruction has been cleared or the safetyreversing sensors have been aligned,the
door will close when the garage door opener is activated.TTC WILL NOT work ifthe garage door opener
is operating by battery power or if the safetyreversing sensors are misaligned. This feature is NOT
intended to be the primary method of closing the door.A keyless entry should be installed in the event
of an accidental lock out when using this feature.
MyQ
®
MyQ
®
technology uses a 900MHz signal to provide two-way communication between the garage door
opener and MyQ
®
enabled accessories.Your garage door opener is compatible with up to 8 MyQ
®
accessories.
REMOTE CONTROLS AND DOOR CONTROLS (MyQ
®
)
Your garage door opener hasalready been programmed at the factory to operate with your remote
control,which changes with each use, randomly accessing over 100 billion new codes.Compatible with
MyQ
®
enabled accessories,see page 40.
NOTE: Older Chamberlain remote controls,door controls, and third party products are not compatible.
MyQ
®
Accessories MEMORY CAPACITY
Remote Controls
Door Controls
Keyless Entries
Up to 8
Up to 2 MyQ
®
door controls
Up to 1
THE PROTECTOR SYSTEM
®
(SAFETY REVERSING SENSORS)
When properly connected and aligned,the safetyreversing sensors will detect an obstruction in the path
of the infrared beam.Ifan obstruction breaksthe infrared beam while the door is closing, the door will
stop and reverse to full open position, and the opener lights will flash 10 times. If the door is fully open,
and the safety reversing sensors are notinstalled, or are misaligned, the door will not close from a
remote control. However,you can close the door if you hold the button on the door control or keyless
entry until the door isfully closed. The safetyreversing sensors do not effect the opening cycle.
ENERGY CONSERVATION
For energyefficiencythe garage door opener will enter sleep mode when the door is fully closed. The
sleep mode shuts the garage door opener down until activated.The sleep mode is sequenced with the
garage door opener lightbulb; as the lightbulb turns off the sensor LEDs will turn off and whenever the
garage door opener lights turn on the sensor LEDs will light. The garage door opener will not go into the
sleep mode until the garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener lightbulbs will turn on when the opener is initially plugged in;power is restored
after interruption, or when the garage door opener is activated. The lights will turn off automatically after
4-1/2 minutes.An incandescentA19 light bulb (100 watt maximum) or for maximum energy efficiency a
26W (100W equivalent) compactfluorescent light (CFL) bulb may be used.NOTE: Do not use halogen,
short neck, or specialty light bulbs as these may overheat the end panel or light socket. Do not use LED
bulbs as they may reduce the range or performance of your remote controls.
Light Feature
The garage door opener is equipped with an added feature;the lights will turn on when someone enters
through the open garage door and the safetyreversing sensor infrared beam isbroken. For added
control over the light bulbs on your garage door opener,see page 33.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain PD612EV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain PD612EV in the language / languages: English as an attachment in your email.

The manual is 4,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info