555410
12
Zoom out
Zoom in
Previous page
1/16
Next page
12
1
2
21
Replace Light Bulb
Replace light bulb (1) with a 21
watt ma-mum light bulb. Insert
bulb into socket (2) as shown.
The light will turn on and remain
lit for 2 1/2 minutes when power
isconnected.After21/2 minutes
it will turn off.
L
OC
K
L
I
G
HT
8
8
4
2
3
1
W
H
T
2
R
E
D
1
1
2
1
RED
WHT
L
O
C
K
L
IG
H
T
1
2
7
3
5
6
8
9
10
4
L
O
C
K
LI
G
H
T
22
Wiring the Backlit Door Control Button or the (optional) Multi-Function Door Control Panel
Locate any Wall Mounted Door Control where the garage door is visible, away from door and door hardware, at a
minimum height of 1.5m. fasten the child warning label on the wall near the Door Control.
There are 2 screw terminals (1) on the back of the Door Control (2). Strip about 6mm of insulation from bell wire (4).
Separate wires enough to connect the white/red wire to terminal screw 1 and the white wire to terminal screw (1).
Backlit Door Control Button: Fasten to an inside garage wall with sheet metal screws (3) provided with Backlit Push
Button. Drill 4mm holes and use anchors (6) if installing into drywall or concrete.Aconvenient place is beside the service
door and out of reach of children.
Multifunction Door Control (optional): Insert a small flat head screwdriver into the top of the Wall Control (10), gently
pry the cover off. Fasten to an inside garage wall with sheet metal screws (8) as follows:
Install bottom screw, allowing 3mm to protrude from the wall.
Position bottom of door control over screw head and adjust for snug fit.
Install top screw with care to avoid cracking plastic housing.
Do not over tighten.
Replace cover by inserting bottom tabs (9) and snapping into place. To remove cover after mounting, gently pry at top
with paper clip or small flat head screwdriver.
Run the bell wire up the wall and across the ceiling to the garage door opener. Use insulated staples (5) to secure wire.
The opener Quick-Connect Terminals (7)arelocated in the recess nexttothe learn button on the leftsidepanel. Insert bell
wire into holes in the Quick Connect Terminals as follows: Red/White to Red and White to White.
8
9
7
3
2
5
4
L
O
C
K
L
I
G
H
T
6
1
23
Accessories
(1) Model84330AML Single Function Remote Control
(2) Model84335AML 3-Function Mini Remote Control
(3) Model84333AML 3- Function Remote Control
(4) Model770AML The Protector System
(5) Model 8747AML Wireless Keyless Entry Keypad
(6) Model845AML Multi-Function Door Control Panel
(7) Model75AML Backlit Door Control Button
(8) Model760AML Outside Keylock
(9) Model1702AML Outside Quick Release
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain ML500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain ML500 in the language / languages: English as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info