600899

Chamberlain Liftmaster 2280-267C Manual

48
Zoom out
Zoom in
Previous page
1/72
Next page
Cornière
(Non fournie)
PLAFOND FINI
Solive cachée
(Non fournis)
Boulon de 5/16 po-18 x
7/8 de po, Rondelle-frein
de 5/16 po, Écrou de
5/16 po-18
Tire-fond de
5/16 po x18x1-7/8 po
Mesurer
la distance
Tire-fond de
5/16 po x 18 x 1-7/8 po
Solives
Boulon de 5/16 po-18 x 7/8 po,
Rondelle-frein de 5/16 po,
Écrou de 5/16 po-18
Boulon de 5/16 po-18 x 7/8 de po,
Rondelle-frein de 5/16 po,
Écrou de 5/16 po-18
B
oulon de 5/16 po-18 x 7/8 po,
R
ondelle-frein de 5/16 po,
É
crou de 5/16 po-18
Tire-fond de
5/16 po x18x1-7/8 po
PLAFOND FINI
(Non fournis)
Boulon de 5/16 po-18 x
7/8 de po, Rondelle-frein
de 5/16 po, Écrou de
5/16 po-18
12
Figure 1
Figure 2
POSE - 5
e
OPÉRATION
Accrochage de l’ouvre-porte
Les illustrations représentent trois poses types. La pose
peut toutefois être différente. Les supports de suspension
doivent être inclinés (Figure 1) pour assurer un support
rigide. Dans le cas d’un plafond fini (Figure 2 et Figure 3),
fixer une cornière aux solives du plafond avant de poser
l’ouvre-porte. La cornière et les fixations ne sont pas
fournies.
1. Mesurer, de chaque côté de l’ouvre-porte, la distance
entre l’ouvre-porte et les solives.
2. Couper les deux supports de suspension à la longueur
requise.
3. Percer des avant-trous de 3/16 pouce dans les solives.
4. Fixer une extrémité de chaque support de suspension
sur une solive avec des tire-fond de 5/16 po -18 x 1-7/8
po.
5. Fixer l’ouvre-porte aux supports de suspension à l’aide
de boulons hexagonaux de 5/16 po-18 x 7/8 po, de
rondelles-frein et d’écrous.
6. S’assurer que le rail est centré au-dessus de la porte
(ou dans le prolongement du support de linteau si le
support n’est pas centré au-dessus de la porte).
7. Retirer le 2 x 4. Faire fonctionner la porte manuellement.
Si la porte frappe le rail, lever le support de linteau.
8. Graisser le dessus et le dessous de la surface du rail où
glisse le chariot à l’aide de graisse à rail.
REMARQUE : NE PAS mettre l’ouvre-porte sous tension à
ce stade.
Tire-fond de 5/16 po-18 x 1-7/8 po
Boulon hexagonal de
5/16 po-18 x 7/8 po
Écrou de
5/16 po-18
Rondelle-frein
de 5/16 po
Pour éviter d’éventuelles BLESSURES GRAVES par suite de la
chute d’un ouvre-porte de garage, fixer l’ouvre-porte
SOLIDEMENT aux solives du garage. On DOIT utiliser des
ancrages de béton si les supports sont posés dans la
maçonnerie.
ATTENTION
AVERTISSEMENT AVERTISSEMENT
AVERTISSEMENT
AVERTISSEMENT
GRANDEUR RÉELLE DES FIXATIONS
Figure 3
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Chamberlain Liftmaster 2280-267C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Chamberlain Liftmaster 2280-267C in the language / languages: English as an attachment in your email.

The manual is 5,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info