780082
11
Zoom out
Zoom in
Previous page
1/23
Next page
19 20
1. Feed electric cable through
each side of the basebar from
the front.
2. With brake lines already
installed in frame and exiting
from the top tube cable port
and fork, push through from
back of bar.
3. Install brake levers as per
manufacturers instructions.
SPLIT BASEBAR WIRING
Low Position
High Position
1. Lightly grease the threads of the four M5 stem
xing screws.
2. Position both halves of the base bars as shown
in the high or low conguration as determined
during tting.
3. Install the Basebar Plate and hold the
assembly in place.
4. Insert the four greased M5 xing screws as
shown to x the basebar into place.
5. Tighten to 6Nm maximum torque.
SPLIT BASEBAR INSTALLATION
Basebar Fixing
Screws M6 x 25mm
Basebar Top Plate
(HBP-HB10-BMP)
Basebar (right(
(HBP-0E0PXBASR)
Basebar (left)
(HBP-0E0PXBASL)
Stem Steerer Clamp
(ST-ST30)
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cervelo PX-Series - 2020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cervelo PX-Series - 2020 in the language / languages: English as an attachment in your email.

The manual is 10.05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info