780083
27
Zoom out
Zoom in
Previous page
1/68
Next page
I General User Manual 27
18.6 Fitting the wheel
Please note that the work steps described here are for a
specic example.
Please observe the information om the relevant manu-
facturer or consult your specialist cycle shop.
18.6.1 Inserting the ont wheel
Bear the running direction of the tyre in mind when
tting the ont wheel.
If your bike is equipped with a disc brake, make sure
that the brake discs are correctly positioned between
the brake pads.
18.6.2 Inserting the rear wheel
18.6.2.1 Bikes with derailleur gears
If your bike is equipped with derailleur gears, put
the chain back onto the smallest sprocket when
tting the rear wheel.
Insert the wheel as far as it will go so it sits cen-
trally in the dropouts.
Tighten the hub nut, or rmly close the quick-
release device (see Chapter 9.2.2 "Operating the
quick-release device").
18.6.2.2 Bikes with hub gears
Fitting a wheel with gear hub in the ame
1. Fit the chain on the sprocket and oer up the
hub axle to the dropouts.
CJ-NX10
JAPAN
Hub axle
Dropout
18.5 Fitting the tyre and inner tube
Make sure that foreign bodies do not enter the inside
of the tyre. Make sure that the inner tube is crease-
ee and not pinched at all times. When tting the
tyre, bear in mind the running direction. If the tyre
has a running direction, this will be indicated on the
tyre sidewall.
Make sure that the rim tape covers the spoke nip-
ples and is undamaged.
Put the rim with one edge inside the tyre.
Push one side of the tyre completely into the rim.
Insert the valve through the valve hole in the rim
and t the inner tube inside the tyre.
Push the tyre over the rim sidewall.
Pull the tyre forcelly into the centre of the rim.
The area that has already been tted will slip into
the base of the rim.
Check once again that the inner tube is seated
correctly.
Push the other side of the tyre completely over the
rim ange using the heel of your hand.
With Dunlop or Woods valves: Put the valve insert
back into position and screw the cap nut tight.
Inate the inner tube slightly.
Check that the tyre is correctly seated and is true
using the indicator ring on the rim sidewall. Adjust
the seating of the tyre by hand if it does not run
straight.
Inate the inner tube up to the recommended tyre
pressure.
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cervelo General - 2012 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cervelo General - 2012 in the language / languages: English as an attachment in your email.

The manual is 10.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Cervelo General - 2012

Cervelo General - 2012 User Manual - German - 68 pages

Cervelo General - 2012 User Manual - Dutch - 68 pages

Cervelo General - 2012 User Manual - French - 68 pages

Cervelo General - 2012 User Manual - Italian - 68 pages

Cervelo General - 2012 User Manual - Spanish - 68 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info