667020
5
Zoom out
Zoom in
Previous page
1/8
Next page
ENGLISH | 5
ALIGNING THE STARPOINTER FINDERSCOPE
The StarPointer fi nderscope helps you aim your telescope by looking through its round glass window and covering your
target with the red dot projected in the window.
The fi rst time you assemble your telescope, you’ll need to align the StarPointer with the main optics of the telescope.
Although this step can be done at night, it is signifi cantly easier during the day. Once you have completed the
nderscope alignment, you should not have to repeat this step unless the fi nderscope is bumped or dropped.
To align the StarPointer:
1. Take the telescope outside during the day. Using your naked eye, fi nd an easily recognizable object, such as a
streetlight, car license plate, or tall tree. The object should be as far away as possible, but at least a quarter mile away.
2. Remove the main dust cover from the telescope and make sure your 20 mm eyepiece in installed.
3. Move the telescope left and right or up and down so that it is roughly pointing toward the object you chose in step 1.
4. Look through the telescope using your 20 mm eyepiece and manually move the telescope until the object you chose
lies in the center of the view. If the image is blurry, gently turn the focus knobs until it comes into sharp focus.
5. Once the object is centered in your 20 mm eyepiece, turn on the fi nderscope by turning the power switch knob
clockwise as far as it will go.
6. With your head positioned about a foot behind the fi nder, look through the round window and locate the red dot. It
will probably be close to, but not on top of, the object you see when you are looking through the 20 mm eyepiece.
7. Without moving the telescope, use the two adjustment knobs on the side and underneath the StarPointer. One
controls the left-right motion of the dot, while the other controls the up-down motion. Adjust both until the red dot
appears over the same object you are observing in the 20 mm eyepiece.
Now choose some other distant targets to practice aiming your telescope. Look through the StarPointer window and
place the red dot on the target you are trying to view and verify that it is the 20 mm eyepiece of the scope.
With your StarPointer fi nderscope aligned, your telescope is fully assembled and you are ready to observe!
NOTE: Be sure to turn off the StarPointer fi nderscope when not in use to conserve battery power.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Celestron NPF EXPLORASCOPE 60AZ - 22105 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Celestron NPF EXPLORASCOPE 60AZ - 22105 in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info