667039

Celestron CGEM 1100 Manual

8
Zoom out
Zoom in
Previous page
1/71
Next page
8
A
A
t
t
t
t
a
a
c
c
h
h
i
i
n
n
g
g
t
t
h
h
e
e
A
A
c
c
c
c
e
e
s
s
s
s
o
o
r
r
y
y
T
T
r
r
a
a
y
y
1. Slide the accessory tray over the central rod so that each arm of the tray is pushing against the inside of the tripod legs.
2. Thread the accessory tray knob on to the central rod and tighten.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
u
u
n
n
t
t
e
e
r
r
w
w
e
e
i
i
g
g
h
h
t
t
B
B
a
a
r
r
To properly balance the telescope, the mount comes
with a counterweight bar and at least one
counterweight (depending on model). To install the
counterweight bar:
1. Locate the counterweight bar locking nut from the box
containing the CGEM mount (see Fig 2-5).
2. Thread the counterweight bar through the rounded end
of locking nut until the threads pass all the way
through and the locking nut can go no further.
3. Locate the opening in the equatorial mount on the
DEC axis
4. Thread the counterweight bar into the opening until tight.
5. Tighten the counterweight bar lock nut fully for added support.
Once the bar is securely in place you are ready to attach the counterweight.
Since the fully assembled telescope can be quite heavy, position the mount so that the polar axis is pointing towards
north before the tube assembly and counterweights are attached. This will make the polar alignment procedure much
easier.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
u
u
n
n
t
t
e
e
r
r
w
w
e
e
i
i
g
g
h
h
t
t
Depending on which telescope model you have, you will receive either one, two or three counterweights. To install the
counterweight(s):
1. Orient the mount so that the counterweight bar points toward the ground .
2. Remove the counterweight safety screw on the end of the counterweight bar (i.e.,
opposite the end that attaches to the mount).
3. Loosen the locking screw on the side of the counterweight.
4. Slide the counterweight onto the shaft (see Figure 2-5).
5. Tighten the locking screw on the side of the weight to hold the counterweight in
place.
6. Replace the counterweight safety screw.
Figure 2-4
Mounting Knob
Central Rod
Accessory Tray
Accessory
Tray Knob
Figure 2-5 – Mount shown with two
counterweights (CGEM 925 & 1100)
Counterweight
Safety Sc
rew
Counterweight
Locking Screw
Counterweight Bar
Locking Nut
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Celestron CGEM 1100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Celestron CGEM 1100 in the language / languages: English as an attachment in your email.

The manual is 4,91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info