580485

Celestron AstroMaster 130 EQ-MD Manual

8
Zoom out
Zoom in
Previous page
1/32
Next page
8
A
A
t
t
t
t
a
a
c
c
h
h
i
i
n
n
g
g
t
t
h
h
e
e
S
S
l
l
o
o
w
w
M
M
o
o
t
t
i
i
o
o
n
n
C
C
a
a
b
b
l
l
e
e
s
s
The AstroMaster mount comes with two slow motion control cables that allow you to make fine pointing
adjustments to the telescope in both R.A. and Declination. To install the cables:
1. Locate the two cables with knobs on them (both are identical is size and length) and make sure the screw on
each cable end does not protrude through the opening.
2. Slide the cable onto the R.A. shaft as far as it will go. There are two R.A. shafts, one on either side of the
mount. It makes no difference which shaft you use since both work the same. Use whichever one you find
more convenient.
3. Tighten the screw on the R.A. cable to hold it securely in place.
4. The DEC slow motion cable attaches in the same manner as the R.A. cable. The shaft that the DEC slow
motion knob fits over is toward the top of the mount, just below the telescope mounting platform.
Figure 2-15 Figure 2-16
R.A. Shaft on bottom and Dec. Shaft on top R.A. & Dec. Cables with knobs attached
A
A
t
t
t
t
a
a
c
c
h
h
i
i
n
n
g
g
t
t
h
h
e
e
T
T
e
e
l
l
e
e
s
s
c
c
o
o
p
p
e
e
T
T
u
u
b
b
e
e
t
t
o
o
t
t
h
h
e
e
M
M
o
o
u
u
n
n
t
t
The telescope optical tube attaches to the mount via a dovetail slide bar mounting bracket at the top of the mount
(Figure 2-16). For the 130 EQ Newtonian, the mounting bar is the bracket which is attached to the tube rings. For
the 90 EQ refractor the mounting bar is attached along the bottom of the telescope tube. Before you attach the
optical tube, make sure that the declination and right ascension locking knobs are tight (Figure 2-17). Then,
make sure that the latitude adjustment screws (Figures 1-1 & 1-2) are tight. This will ensure that the mount
does not move suddenly while attaching the telescope optical tube. Also, remove the objective lens cap (refractor) or
the front opening cap (Newtonian). To mount the telescope tube:
1. Remove the protective paper covering the optical tube. You will have to remove the tube rings on the 114 EQ
Newtonian before removing the paper.
2. Loosen the mounting knob and the mounting safety screw on the side of the dovetail mounting platform so they
do not protrude into the mounting platform – see Figure 2-18.
3. Slide the dovetail mounting bar into the recess on the top of the mounting platform (figure 2-17).
4. Tighten the mounting knob on the dovetail mounting platform to hold the telescope in place.
5. Hand tighten the mounting platform safety screw until the tip touches the side of the mounting bracket.
NOTE: Never loosen any of the knobs on the telescope tube or mount other than the R.A. and DEC. knobs.
Hint: For maximum rigidity of the telescope and mount, make sure the knobs/screws holding the tripod legs to
the tripod head are tight.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Celestron AstroMaster 130 EQ-MD at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Celestron AstroMaster 130 EQ-MD in the language / languages: English as an attachment in your email.

The manual is 10 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Celestron AstroMaster 130 EQ-MD

Celestron AstroMaster 130 EQ-MD User Manual - German - 32 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info