482685
6
Zoom out
Zoom in
Previous page
1/30
Next page
Press “RAIN HISTORY” repeatedly to scroll through the history data corresponding to your
selection. On the bar shown in the rainfall display area, the “0” represents the current period
and the “-1”, “-2”, etc. indicate the prior periods. As an example, during the month of April,
press the “RAIN HISTORY” button repeatedly in the monthly mode until “-3” bar chart is
shown. The bar chart and reading indicate the monthly rainfall record for the month of January
(1
st
through 31
st
).
Alarm Setting – press the “ALARM” button to show the alarm time and the “ALARM” icon
will appear. Press again to enable or disable the alarm – when enabled a bell icon will appear”.
Press and hold the “ALARM” button to
enter the setting mode. Enter the desired
hour and minute values by pressing the
“UP” and “DOWN” button and then
pressing “ALARM” to set each.
Snooze – when the alarm goes off, press
“SNOOZE/LIGHT” button (rear of
Receiver) to go into snooze mode and the
alarm will go off again in 10 minutes and
continue over and over as long as you hit
the “SNOOZE”. To stop the snooze or
alarm, press the “ALARM” button.
Channel – if your Sensor is set correctly to Channel 1, then a small icon to the left of wind chill
display will show “ch1”. If you do not have an outdoor temperature and humidity display, make
sure that the “1” is displayed and if not (shows a 2 or 3), then push the “CH” button until is
shows the “1”.
Low Battery Indication – the Receiver and remote sensors will be display an icon and you
should change batteries as soon as possible.
Placement – the Receiver can be put on a table, desk, or other flat surface or it can (by using a
hanger cut out (in two places) on the rear of the Receiver) be hung on a wall or other location.
Specifications:
Indoor Temperature Range = 0º to +50º C (+ 32º to + 122º F)
Remote Sensor Temperature Range = -20º to + 60º C ( -4º to + 140º F)
Indoor/Outdoor Humidity Range = 20% to 99% Relative Humidity
Resolution = ± .5º C (± 1.5º F) for temperature & ± 1.5% humidity
Wind Speed Range = 0 to 108 km/h, 0 to 67 mph, 0 to 30 m/s, 0 to 58 knots, 0 to 11 Beaufort
Rain Gauge Reading = 0 to 9999mm, 0 to 394 in
Clock = digital quartz
Transmission = RF433 MHz
Dimensions = Receiver – 7.6” x 1.1” x 4.5” (193x28x114mm) Anemometer/Sensor – 8.0” x 7.8” x
14.3” (203x198x363mm) Rain Gauge – 5.8” x 2.3” x 3.3” (147x58x84mm)
Weight = Receiver - 15oz/425g Sensor - 9oz/255g Rain Gauge - 6oz/170g
2835 Columbia St.
Torrance, California 90503 U.S.A.
www.celestron.com
Printed in China 0110
RoHS
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Celestron 47009 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Celestron 47009 in the language / languages: English as an attachment in your email.

The manual is 0,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info