753604
17
Zoom out
Zoom in
Previous page
1/85
Next page
3332
ENGLISH ENGLISH
7. Charging terminals
8. Battery
9. Side brush
10. Bumper
11. Motor cover
12. Main brush: for cleaning all types of surfaces
13. Left side wheel
14. Right side wheel
15. Silicone brush: special for pet hair
16. Cepillo Jalisco (brush): specific for hard floors
17. Optical sensor: specific for preventing the robot from bumping
Fig. 3
Wet & dry tank
Water compartment
1. Tank lock
2. Water inlet
3. Water tank
Fig. 4
Dust compartment
1. High-efficiency filter
2. Dust compartment
Fig. 5
Dust tank
1. Dust tank
2. Primary filter
3. High-efficiency filter
4. Dust tank cover
Fig. 6
Charging base
1. Signal transmission area
2. Charging terminals
3. Charge indicator
4. Cable slot
5. Charging terminals
Fig. 7
Mop bracket and cloth
1. Mop cloth
2. Mop bracket
3. Velcro
4. Tab
3. BEFORE US
Take the product out of the box and remove all packaging material.
Make sure all parts and components are included and in good conditions. If any visible signs of
damage are observed, contact the Technical Support Service immediately.
4. INSTALLATION
Fig. 8
Robot and charging base installation
Connect the charging base to a power supply and store the remaining cable. It is important to
store the remaining cable at the bottom of the charging base to avoid it from being dragged
and disconnected.
Fig. 9
Place the charging base against the wall, leaving the safety distance indicated in the picture
below.
Warning: Do not expose the charging base to direct sun light.
Long press the on/off button for 3 seconds; when the light indicator turns on, place the robot
on the charging base.
Steady blue light: On/operating
Orange light blinks: charging
Red light blinks: error
Fig. 10
Note:
Take the robot to the charging base if the battery is low. The robot might not turn on if the
battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned off during charging.
Wet & dry tank installation
Note: It is not suggested to use the scrubbing function for the first-time use.
Open the tank’s rubber lid, fill the tank with water carefully so water does not come out and
close it again. Make sure the silicone clip is properly closed to avoid water from spilling.
Fig. 11
Install the tank in the robot following the indicated direction. Make sure the clip is properly
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Cecotec Conga 5090 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Cecotec Conga 5090 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 2,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info