532900
10
Zoom out
Zoom in
Previous page
1/16
Next page
-10-
D. Operation Instruction
1. Before using, check whether the power supply installation is regular to make sure
the supplied voltage is coordinated with the using one.
2. Put the plug in the socket and turn on the power.
3. Turn the temperature controller clockwise to the temperature needed. The yellow
indicator is on that shows heating wire begins to heat and the upper and lower
griddle begins to raise temperature.
4. Temperature can be adjusted according to different food preferably within
180 °C ~ 250 °C. About 8 minutes is needed for the temperature to be raised to
250 °C from the power is on.
5. When the temperature reaches 250 °C, lift the upper module plate to a suitable
place by operation handle. Put some edible vegetable oil on the lower module plate
and constantly place the food on it. Close the plates and press the handle lightly.
Keep an eye on the food until it is suitably done.
6. When temperature reaches the setting degree, temperature controller can cut off
power supply automatically. At the same time, yellow indicator is off and green
indicator is on. It shows that electricity heating tube stops working for next turn.
7. At the lower front of the lower module is the oil tray. Substantial vegetable oil and
the animal oil from the meat grilled ow to the oil tray from the lower module plate.
8. Lift the upper module plate to take the sandwich and other food already done.
9. When the temperature is a bit lower, the temperature controller can get through
power supply automatically. The heating tubes restart to work to heat the module
plates.
10. On completion of the work, temperature controller should be turned to the “off”
place. Unplug the equipment and cut off the power.
11. Notice: There is temperature limiter in the bottom box, the action temperature is
130 °C, and reset temperature is <40 °C. When temperature is over the protective
button works for protection. When use it again, please use it after press the
protective button.
E. Cleaning and Maintenance
1. Cut off the power supply before cleaning in case of accident.
2. Do not use wet towel with non-corrosive cleanser to clean the module plate, the
surface of the equipment and power cord. Direct wash by water is not permitted in
case of any damage of the functions.
3. If do not use it at any time, please turn off temperature controller and main switch.
4. Please store the equipment in a ventilated storehouse without corrosive gas after
cleaning when ceasing its work for a long time.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Caterchef SOLO GRANDE PLUS 688410 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Caterchef SOLO GRANDE PLUS 688410 in the language / languages: English, Dutch, French as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info