723308
14
Zoom out
Zoom in
Previous page
1/23
Next page
EN-12
Power Requirements
Remove the battery compartment cover located in
the center of TRACKFORMER’s bottom panel, and
load six AA-size batteries into the battery
compartment. Make sure the plus and minus ends of
the batteries are facing as shown in the illustration.
Low Battery Indication
The following shows the amount of operating time that
can be expected under battery power.
Approximately 4 hours
Using a high volume setting, low ambient
temperature, and certain performance styles can
shorten battery life.
IMPORTANT!
General guidelines concerning battery life are
provided above. Note that actual battery life depends
on the type of battery being used.
Replace batteries at least once a year. In particular,
leaving dead rechargeable (eneloop, EVOLTA)
batteries loaded in the product creates the risk of
deterioration of the rechargeable batteries. Remove
batteries from TRACKFORMER as soon as possible
after they go dead.
Be sure to turn off TRACKFORMER before replacing
batteries.
When replacing batteries, be sure to load a full set of
six new AA-size batteries, or a set of fully charged
AA-size rechargeable batteries (eneloop or
EVOLTA). Using batteries other than those specified
or mixing old and new batteries can greatly shorten
battery life and result in malfunction.
Low battery power is
indicated when the 12
buttons of the EFFECT/
AUTO LOOP area flash.
Replace batteries with new
ones as soon as possible.
While TRACKFORMER is connected to a computer
with a USB cable, it can be operated on the power
supplied over the cable.
IMPORTANT!
Incorrect connections can make normal operation
impossible. Connect TRACKFORMER to a computer
as described by the procedure below.
Once you are able to connect successfully, you can
leave the USB cable connected when you turn off
your computer and/or TRACKFORMER.
Use a USB 2.0 cable.
TRACKFORMER does not charge rechargeable
batteries. (Use the specified charger for charging.)
1.
Turn off TRACKFORMER and then start up
your computer.
Do not start up your computer’s music software yet!
2.
Use a commercially available high-speed
USB 2.0 cable to connect TRACKFORMER
to your computer.
3.
Turn on TRACKFORMER.
For information about how to connect with a computer,
see the separate Tutorial Manual.
4.
Start up music software on your computer.
IMPORTANT!
Be sure to turn on TRACKFORMER before starting
up your computer’s music software.
Using USB Bus Power
USB cable
(A-B type)
USB
A connector
Computer USB port
TRACKFORMER USB port
B connector
XWDJ1-ES-1A.indd 14 2014/11/28 17:15:49
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio XW-DJ1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio XW-DJ1 in the language / languages: English, Spanish as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio XW-DJ1

Casio XW-DJ1 User Manual - German - 23 pages

Casio XW-DJ1 User Manual - Dutch - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info