288831
31
Zoom out
Zoom in
Previous page
1/32
Next page
121
TROUBLESHOOTING
Symptom Probable Cause Action
Other
All buttons and switches do
not operate.
Cannot perform infrared
data communication.
Auto Play starts even
though it is not selected.
Remove batteries and disconnect the AC adaptor if
you are using one. Restore power and turn the
camera on. If this does not work, contact your
dealer or an authorized CASIO service provider.
1. Communicate only with devices that support
IrTran-P protocol.
2. Orient the infrared ports of the two devices so
they are pointed directly at each other (pages
104, 106, 108).
3. Move the sending and receiving devices away
from the source of the problem.
4. Avoid infrared data communication in direct sun-
light.
Turn off screen saver (page 78).
Malfunction due to static electrical charge or
strong impact.
Camera is connected to a computer or QV Color
Printer.
1. Other device does not support IrTran-P protocol.
2. Sending and receiving units are not positioned
correctly.
3. Object blocking the infrared light path, another
device using infrared light is in the vicinity, or
fluorescent lighting.
4. Direct sunlight
Activation of the screen saver.
122
CAN'T PLAY
PANORAMA
CF
CF ERROR
FORMAT
MENU
MESSAGES
CF
NO CARD
DECODE ERROR
DIAL
ERROR
FOLDER FULL
FULL
4. Press the shutter button to start the memory card for-
mat operation.
To interrupt a format operation part way through, turn
off camera power.
Completion of the format operation is indicated by the
message “NO IMAGE” appearing on the monitor
screen. This message also indicates that the memory
card was formatted successfully.
There is no memory card installed in the camera.
The JPEG image file you are trying to display is either
corrupted or is a format that is not compatible with this
camera.
Incorrect dial setting
Error during data communication. Check cable connec-
tions and mode settings.
The folder you are trying to use is full.
Delete some images you no longer need.
Indicates that movie recording is not possible because
memory card is full.
Delete images you no longer need in camera memory.
Folder is full. Note that each folder can contain up to 250
images.
Not enough memory available for panorama playback.
Delete some images you no longer need and try again.
Perform the following procedure whenever a memory
card starts to behave abnormally.
Important!
The procedure described below deletes all images
stored in the memory card. Make sure all of your im-
portant images are backed up onto a computer hard
disk or other storage medium before performing this
procedure.
To reformat a memory card
1. Connect the AC adaptor to the camera and switch to
AC power or load a new set of batteries into the cam-
era.
Power failure while a format operation is being per-
formed aborts the reformat operation.
2. Press MENU.
3. Use [+] and [–] to select FOR-
MAT, and then press the shutter
button.
Select EXIT if you want to abort the reformat proce-
dure without deleting anything.
123
MEMORY FULL
MEMORY OVER
NO IMAGE
RECORD ERROR
REMAINING
SAME FILENAME
ALREADY EXISTS
SYSTEM ERROR
CALL TECH
SUPPORT
Not enough memory for further recording. Delete
some images from memory card (page 92).
QVIMG folder or other file (page 112) cannot be cre-
ated due to insufficient memory when downloading
data from a computer to the memory card. Use your
computer to delete unneeded images to free up
memory card space for the images you are down-
loading. You could also press the MENU button and
format the memory card in the camera, but doing so
deletes all image files currently stored on the
memory card.
Data being received during infrared data transfer
caused camera memory to become full.
Delete some images you no longer need.
No images are stored in memory card.
This message appears when the image you are trying
to record cannot be compressed for some reason. Try
changing the angle of the camera to the subject.
Not enough memory for recording in the current reso-
lution mode. Change to another resolution mode, or
delete some images from the memory card (pages
44, 92).
The folder to which you are trying to move an image
file already contains another image file with the same
name. Change to another folder and try again.
Problem with internal memory. Contact your dealer or
an authorized CASIO service provider.
MESSAGES
124
SPECIFICATIONS
Image File
Record Format ................... JPEG (with COMPACTFLASH memory
card)
Recording Medium ............ COMPACTFLASH memory card
Recorded Image
Resolution ..........................1280 x 960 pixels / 640 x 480 pixels
Memory Capacity/File Size
S (1280 x 960): ................. 88/14 minimum (500 KB per image)
F (1280 x 960): .................123/19 minimum (350 KB per image)
N (1280 x 960):................. 206/33 minimum (200 KB per image)
E (640 x 480): ................... 340/55 minimum (112 KB per image)
Movie (3.2 seconds): ........ 85/13 groups minimum (5 frames per
second, 1 image =4 frames x 4)
Movie (6.4 seconds): ........ 85/13 groups minimum (10 frames per
second, 1 image =16 frames x 4)
Movie (12.8 seconds): ...... 85/13 groups minimum (5 frames per
second, 1 image =16 frames x 4)
The above figures are approximations only. The actual number of
images depends on image subject matter.
Values such as 85/13 indicate the number of images that can be
stored on a 48MB/8MB CompactFlash card.
Image Deletion ................... Single image; all images in a folder; all
images in memory card (with image
protection)
Imaging Element................ 1/3-inch square pixel color CCD (Total
Pixels: 1,320,000; Effective Pixels:
1,250,000)
Lens ....................................F2.8 to 3.5 f = 5.0 to 10.0mm (equiva-
lent to 32 to 64mm on a 35mm camera)
Zoom ...................................2X optical zoom, 8X digital zoom (when
used in combination with optical zoom)*
Focusing ............................. Phase-difference detection system
auto focus, manual focus; with macro
mode and focus lock
Focus Range ......................(from surface of lens protection filter)
0.25m (0.8') to (standard)/10cm (4")
(macro) (10cm to (4" to ) with
manual focus)
The above figures are approximations
only.
Exposure ............................ Light Metering:
Multi-pattern/spot metering by CCD
Exposure:
Program AE, aperture priority AE
Exposure Compensation:
–2EV to +2EV (1/4EV units)
Shutter ................................ CCD shutter, mechanical shutter
Shutter Speed ....................1/4 to 1/1000 second (1 second in Night
Mode)
Aperture.............................. F2.8 to F14 automatic and manual
switching
White Balance .................... Automatic, fixed (4 modes), manual
switching
Self-timer ............................10 seconds, 2 seconds
Flash Modes ....................... AUTO, ON, OFF, Red-eye reduction
Flash Range .......................Approximately 0.7 to 2 meters (2.3' to
6.6')
Recording Functions ........ Single image; self-timer; movie; pan-
orama; timer; title; macro; mono-
chrome; sepia; Sports Mode; Night
Mode
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio qv 7000sx at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio qv 7000sx in the language / languages: English as an attachment in your email.

The manual is 1,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info