14279
31
Zoom out
Zoom in
Previous page
1/55
Next page
20020601
English
Activity: Operating the EquipmentActivity: Operating the Equipment
MeasurementMeasurement
2-9-2
í Measuring Data
u Prepare the Voltage Measurement Setup. At the same time you start the measurement
operation, move the switch to “ON” to connect the power supply.
u Wait until the circuit achieves a steady state.
u Prepare the Voltage Measurement Setup. At the same time you start the measurement
operation, move the switch to “OFF” to disconnect the power supply.
u Wait until the circuit achieves a steady state.
u Perform the above operation for the RC series circuit and the RL series circuit.
u Read and check the RC and R/L values from the graph.
í Calculator Operation
u Perform the following operation to prepare for voltage measurement using the voltage
probe.
Using E-CON
Using a Calculator Program
Find the applicable program in the Program Library (P.2-16-3), input it into your calculator,
and then run it.
u Graph results for when the power supply is connected and for when it is disconnected.
Voltage Change when Power Is Connected
Voltage Change when Power Is Disconnected
1 Switch
2 Power Supply
Connected
3 Power Supply Cut
55555555555555555555555
5555555555555555555555
555555555
Other Things To Do
555555555
u It appears as if combining the curve during capacitor charging and the curve
during capacitor discharging will produce a straight line with no change over time.
This, however, is not necessarily so. Consider the reason for this.
u In the case of the coil voltage curves as well, it appears as combining them as
expressions should produce a straight line. However, this also does not happen.
Consider the reason for this.
u Change the resistor, capacitor, and coil and find out how the voltage is affected.
u While the capacitor is charged, cut off the power supply and observe changes in
capacitor voltage with the circuit left open. Compare what you observe with the
change in voltage when the circuit is closed.
1 Switch
2 Power Supply
Connected
3 Power Supply Cut
m“E-CON”w1(SETUP)b(Wizard)w
1(CASIO)b(Volt) 0.02w255w1(YES)
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio EA200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio EA200 in the language / languages: English as an attachment in your email.

The manual is 2,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info