624954

Casio 5338 - BA-112 Manual

4
Zoom out
Zoom in
Previous page
1/5
Next page
Operation Guide 5338
E-30
3. Use D (+) and B (–) to change the hours and minutes settings.
To count down from 24hours, set a start time of 0:00.
4. Press A to exit the setting mode.
To perform a countdown timer operation
D
D D D A
Start Stop (Restart) (Stop) Reset
Before starting a countdown timer operation, check to make sure that a
countdown operation is not in progress (indicated by the seconds counting down).
If it is, press D to stop it and then A to reset to the countdown start time.
To stop the alarm
Press any button.
E-31
Adjusting the Analog Hand Setting
Use the following procedure to adjust the analog hands so their settings match the
digital time.
To adjust the analog time
1. In the Timekeeping Mode, hold down D for about
three seconds until the current time start to fl ash. This
is the analog setting mode.
2. Press D to advance the analog time setting by
20seconds.
Holding down D advances the analog time setting
at high speed.
E-32
If you need to advance the analog time setting a long way, hold down D until
the time starts advancing at high speed, and then press B. This locks the high-
speed hand movement, so you can release the two buttons. High-speed hand
movement continues until you press any button. It will also stop automatically
after the time advances 12hours or if an alarm (daily alarm, Hourly Time Signal,
or countdown beeper) starts to sound.
3. Press A to exit the setting mode.
The watch will automatically adjust the minute hand slightly to match its internal
second count when you exit the setting mode.
E-33
Illumination
The face of the watch is illuminated for easy reading in
the dark.
To turn on illumination
In any mode (except when a setting mode, with fl ashing
digits is on the display), press B to illuminate the display.
Illumination Precautions
Illumination may be hard to see when viewed under
direct sunlight.
Illumination turns off automatically whenever an alarm
sounds.
Frequent use of illumination runs down the battery.
E-34
Button Operation Tone
The button operation tone sounds any time you press one
of the watch’s buttons. You can turn the button operation
tone on or off as desired.
Even if you turn off the button operation tone, alarms,
the Hourly Time Signal, and other beepers all operate
normally.
To turn the button operation tone on and off
Hold down C until the button operation tone sounds
(about 3seconds).
This will toggle the button operation tone either ON or
OFF.
The mute indicator is displayed while the button
operation tone is turned off (muted).
The mute indicator is displayed in all modes when the
button operation tone is turned off.
Mute indicator
E-35
Troubleshooting
Time Setting
■ The current time setting is off by hours.
Your Home City setting may be wrong (page E-12). Check your Home City setting and
correct it, if necessary.
■ The current time setting is off by one hour.
You may need to change your Home City’s standard time/daylight saving time
(DST) setting. Use the procedure under “Adjusting the Digital Time and Date
Settings” (page E-15) to change the standard time/daylight saving time (DST) setting.
World Time Mode
■ The time for my World Time City is off in the World Time Mode.
This could be due to incorrect switching between standard time and daylight saving
time. See “To specify standard time or daylight saving time (DST) for a city” (page E-20)
for more information.
E-36
Main Indicators
Number Name See
z
Snooze alarm indicator E-24
x
Alarm indicator E-22
c
Hourly time signal on indicator E-24
v
PM indicator E-11
b
Mute indicator E-34
n
Split indicator E-25
m
DST indicator E-14
,
Graphic indicator
–
+
6 5
*
>
B
@
E-37
, Graphic indicator
Mode Indicator Meaning
Timekeeping
World Time
Alarm
Current second
Countdown Timer Timer seconds
Stopwatch Elapsed 1/10 seconds
E-38
Specifi cations
Accuracy at normal temperature:
±
30 seconds a month
Digital Timekeeping: Hour, minutes, seconds, p.m. (P), month, day, day of the
week
Time format: 12-hour and 24-hour
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: Home City code (can be assigned one of 48 city codes);
Standard Time/Daylight Saving Time (summer time)
Analog Timekeeping: Hour, minutes (hand moves every 20seconds)
World Time: 48 cities (29 time zones)
Other: Daylight Saving Time/Standard Time
Alarms: 5 daily alarms (with 1 snooze alarm); Hourly time signal
Stopwatch:
Measuring unit: 1/100 second
Measuring capacity: 23:59'59.99"
Measuring modes: Elapsed time, split time, two fi nishes
E-39
Countdown Timer:
Measuring unit: 1 second
Countdown range: 24 hours
Countdown start time setting range: 1 minute to 24 hours (1-minute increments)
Illumination: LED (light-emitting diode)
Power Supply: Two silver oxide batteries (Type: SR726W)
Approximately 2 years on type SR726W (assuming alarm operation 20seconds
per day and one illumination operation 1.5seconds per day)
Frequent use of illumination runs down the battery.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5338 - BA-112 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5338 - BA-112 in the language / languages: English as an attachment in your email.

The manual is 0,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5338 - BA-112

Casio 5338 - BA-112 User Manual - German - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info