481349
5
Zoom out
Zoom in
Previous page
1/6
Next page
Operation Guide 5208
E-40
Charging Guide
The following table shows the amount of time the watch needs to be exposed to light
each day in order to generate enough power for normal daily operations.
Exposure Level (Brightness)
Outdoor Sunlight (50,000 lux)
Sunlight Through a Window (10,000 lux)
Daylight Through a Window on a Cloudy Day (5,000 lux)
Indoor Fluorescent Lighting (500 lux)
Approximate
Exposure Time
8 minutes
30 minutes
48 minutes
8 hours
For details about the battery operating time and daily operating conditions, see the
“Power Supply” section of the Specifications (page E-52).
Stable operation is promoted by frequent exposure to light.
E-41
Recovery Times
The table below shows the amount exposure that is required to take the battery from
one level to the next.
Approximate Exposure Time
Level 5 Level 4 Level 3 Level 2 Level 1
3 hours 35 hours 10 hours
10 hours 133 hours 36 hours
16 hours 216 hours 58 hours
194 hours - - - - - - - - - - - - - - - -
Exposure Level
(Brightness)
Outdoor Sunlight
(50,000 lux)
Sunlight Through a
Window (10,000 lux)
Daylight Through a
Window on a Cloudy
Day (5,000 lux)
Indoor Fluorescent
Lighting (500 lux)
The above exposure time values are all for reference only. Actual required exposure
times depend on lighting conditions.
E-42
Adjusting Home Positions
Strong magnetism or impact can cause the hands of the watch to be off. If this
happens, perform the applicable home position adjustment procedures in this section.
Hand home position adjustment is not required if the analog time and digital time are
the same in the Timekeeping Mode.
To adjust home positions
1. In the Timekeeping Mode, hold down A for about five seconds. You can release the
button after H.SET” appears on the display.
Though “ADJ will appear on the display after about two seconds, do not release
the button yet. Keep it depressed until H.SET” appears.
E-43
Correct hour and
minute hand positions
The hour and minute hands should move to 12 o’clock
(their home position), and “0:00 will flash on the
display.
If the hour and minute hands are not at 12 o’clock,
use D (+) and B (–) to move them there.
Holding down either button will cause the hands to
move at high speed. Once started, high-speed hand
movement will continue even if you release the button.
To stop high-speed hand movement, press any button.
High-speed hand movement started with the D (+)
button will stop automatically after 12 revolutions of
the minute hand. If started with the B (–) button, it
will stop after one revolution of the minute hand.
2. After everything is the way you want, press A to return to the Timekeeping Mode.
After performing home position adjustment, enter the Timekeeping Mode and check
to make sure that the analog hands and the digital display indicate the same time. If
they do not, perform home position adjustment again.
E-44
Reference
This section contains more detailed and technical information about watch operation.
It also contains important precautions and notes about the various features and
functions of this watch.
Button Operation Tone
The button operation tone sounds any time you press one of the watch’s buttons. You
can turn the button operation tone on or off as desired.
Even if you turn off the button operation tone, alarms, the Hourly Time Signal, and
other beepers all operate normally.
E-45
To turn the button operation tone on and off
1.
In the Timekeeping Mode, hold down
A
for about two
seconds, until ADJ” appears on the display.
Your current Home City code will be flashing on the
screen.
2. Press C nine times until the current button operation
tone setting (
or ) appears.
3. Press D to toggle the setting between
(tone on)
and
(tone off).
4. Press A to exit the setting screen.
E-46
Power Saving Function
The Power Saving function enters a sleep state
automatically whenever the watch is left in an area for a
certain period where it is dark (except if the watch is in the
Stopwatch or Timer mode). The table below shows how
watch functions are affected by the Power Saving
function.
E-47
Elapsed Time in Dark
60 to 70 minutes
6 or 7 days
Display
Blank
Operation
All functions enabled, except for the display
Beeper tone, illumination, and display disabled
Analog timekeeping stopped at 12 o’clock
Wearing the watch inside the sleeve of clothing can cause it to enter the sleep state.
The watch will not enter the sleep state between 6:00 AM and 9:59 PM. If the watch
is already in the sleep state when 6:00 AM arrives, however, it will remain in the
sleep state.
To recover from the sleep state
Perform any one of the following operations.
Move the watch to a well-lit area.
Press any button.
E-48
Auto Return Features
If you leave the watch in the Alarm Mode, or with the battery level indicator displayed
for two or three minutes without performing any operation, it automatically returns to
the Timekeeping Mode.
If you leave the watch with a flashing setting on the display for two or three minutes
without performing any operation, the watch automatically exits the setting screen.
Scrolling
The B and D buttons are used in various modes and setting screens to scroll
through data on the display. In most cases, holding down these buttons during a scroll
operation scrolls through the data at high speed.
Initial Screens
When you enter the World Time Mode or Alarm Mode, the data you were viewing
when you last exited the mode appears first.
E-49
Timekeeping
Resetting the seconds to 00 while the current count is in the range of 30 to 59
causes the minutes to be increased by 1. In the range of 00 to 29, the seconds are
reset to 00 without changing the minutes.
The year can be set in the range of 2000 to 2099.
The watch’s built-in full automatic calendar makes allowances for different month
lengths and leap years. Once you set the date, there should be no reason to change
it except after you have the watch’s battery replaced or when battery power drops to
Level 5.
The current time for all city codes in the Timekeeping Mode and World Time Mode is
calculated in accordance with the Coordinated Universal Time (UTC) for each city,
based on your Home City time setting.
Illumination Precautions
Illumination may be hard to see when viewed under direct sunlight.
Illumination automatically dims if it is lit and an alarm or time up alarm sounds.
Frequent use of illumination runs down the battery.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Casio 5208 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Casio 5208 in the language / languages: English as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Casio 5208

Casio 5208 User Manual - German - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info