134526
7
Zoom out
Zoom in
Previous page
1/101
Next page
EN
When the installation plate is directly mounted on the wall
1.Securely fit the installation plate onto the wall by screwing it in the
upper and lower parts to hook up the indoor unit.
2.To mount the installation plate on a concrete wall with anchor
bolts, use the anchor bolt holes as illustrated in the below figure.
3.Install the installation plate horizontally in the wall.
CAUTION
Failure to firmly install the unit may result in personal injury and
property damage if the unit falls.
In case of block, brick, concrete or similar type walls, make 5 mm
dia. holes in the wall.
Insert clip anchors for appropriate mounting screws 7.
CAUTION
When installing the installation plate with a mounting screw,
do not use the anchor bolt holes. Otherwise, the unit may fall
down and result in personal injury and property damage.
NOTE
Secure four corners and lower parts of the installation plate with
4 to 6 mounting screws to install it.
5 m
5
m
45°
4
5
°
7
5
°
* 7 m
7 m
INDOOR UNIT
Installation Place
A place which provides the spaces around the indoor unit as
shown in the diagram
A place where there are no obstacles near the air inlet and outlet
A place which allows easy installation of the piping to the outdoor
unit
A place which allows the front panel to be opened
The indoor unit shall be installed as top of the indoor unit comes
to at least 2 m height.
Also, it must be avoided to put anything on
the top of the indoor unit.
CAUTION
Direct sunlight to the indoor unit’s wireless receiver should be
avoided.
The microprocessor in the indoor unit should not be too close
to RF noise sources.
(For details, see the owner’s manual.)
(Top view)
* : Axial distance
Reception
range
Reception range
Remote
control
Indoor unit
Remote control
(Side view)
Remote control
A place where there are no obstacles such as a curtain that may
block the signal from the indoor unit
Do not install the remote control in a place exposed to direct
sunlight or close to a heating source such as a stove.
Keep the remote control at least 1 m apart from the nearest TV
set or stereo equipment. (This is necessary to prevent image
disturbances or noise interference.)
The location of the remote control should be determined as
shown below.
Cutting a hole
When installing the refrigerant pipes from the rear
The center of the pipe hole
is above the arrow.
Cutting a Hole and Mounting
Installation Plate
NOTE
When drilling a wall that contains a metal lath, wire lath or metal
plate, be sure to use a pipe hole brim ring sold separately.
1.After determining the pipe hole position on the mounting plate
(A), drill the pipe hole (65 mm) at a slight downward slant to
the outdoor side.
65 mm
100 mm
Pipe hole
Indoor unit
62
85
82.5
170
Anchor bolt holes
Hook
Pipe hole
Indoor unit
Thread
Hook
Weight
Pipe hole
7 Mounting screw
Hook
1
Installation
plate
2 m or more from floor
Mounting the installation plate
3
Installation plate
(Keep horizontal direction.)
Projection
15 mm or less
Anchor bolt
Clip anchor
(local parts)
Clip anchor
(local parts)
5 mm dia. hole
7 Mounting screw
4 x 25
ss
ss
s
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrier 42hqv035 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrier 42hqv035 in the language / languages: English, German, Dutch, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info