790627
6
Zoom out
Zoom in
Previous page
1/58
Next page
72GB-5
 
2. OPEATION
2.3 HOW IT WORKS
In this setting the system will automatically change modes and fan speed to the set temperature.
[In spring and autumn, closer temperature control may require COOL/HEAT mode changes.]
In this mode, priority is given to dehumidifying the air. Low fan speed and compressor cycling is used to achieve this and regulate room
temperature.
AUTO Mode
DRY Mode
Basic Operation ModesAUTO / COOL / DRY / HEAT / FAN
At start-up, a time delay of 3 to 4 minutes protects the compressor.
Compressor Delay
To avoid uncomfortable drafts in heating mode, the indoor unit is preheated before the fan starts. This delay should only last a few
minutes.
Cold Draft Prevention
The unit will automatically restart after a power interruption. Previous user settings are all recovered.
Auto Restart*
When refrigerant leakage is detected, the unit will display “EC” code or flash LEDs.
Auto Leak Detection*
[*] Model dependent
Louver angle is memorised and will return to the position last selected by the user.
Louver Memory*
Press “AIR DIRECTION” on remote controller to adjust air flow
direction. The louver position moves slightly each time the
button is pressed. Adjust the louver upwards in cooling mode
while downwards in heating mode to achieve best comfort.
Adjusting Air Flow Direction
Please refer to the REMOTE CONTROLLER MANUAL
for details.
In cooling or dry mode, condensate may form and drip
from unit in high humidity condition if louver position is
in Maximum down.
Do not operater the unit with louver closed or narrow
opening. Restricted air flow reduced performance and
may cause condensate.
NOTE
CAUTION
Do not attempt to adjust the horizontal louver by hand.
Be alert to the moving part when adjust vertical louver. Accidental contact with the fan may cause serious injury.
Disconnect from power source before opening the front panel.
Upward (Cooling) Horizontal Louver Swing
Ice develops on the outdoor unit in heating mode. To defrost this ice, the indoor fan stops for a few minutes before heating continues.
Auto Defrost
Press “SWING” to engage continous horizontal louver
motion.
Downwards (Heating)
For vertical louver, move the levers left or right to guide
the air in desired direction.
Adjust Vertical Louver
Levers
Air Flow Selection Switch
The draft can be selected to come out from both upper and lower
air outlet or from upper air outlet only.
Open the front panel to get to the Air Flow selection switch.
Selection Switch
Air Flow
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrier 38QUS018DS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrier 38QUS018DS2 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 6.24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info