469921
10
Zoom out
Zoom in
Previous page
1/100
Next page
10
Setting of car address



While the car address is displayed, in addition a dot will turn up in
the segment display bottom right, g.
. Switch on the Control Unit,
g.
; the up-to-date car address
will be indicated for approx.
3 seconds. By pushing the control button
the car address can
be changed to another address. Push the button
as many times
till the desired address
will be shown. After 3 seconds the seg-
ment display
will change to the race position again.
Maintenance and care
To ensure a proper operation of the motor-racing circuit, all race-
track components should be regularly cleaned. Pull the plug prior
to cleaning.
 Keep the track surface and track slots clean with a
dry cloth. Do not use any solvents or chemicals for cleaning. When
it is not in use, store the racetrack in a clean and dust-protected
location, preferably in the original cardboard box.
Important information






Please note that Exclusiv/Evolution (analog system) and Carrera
DIGITAL 124/132 (digital system) involve two separate and com-
pletely independent systems. We hereby expressly indicate that
both systems must be kept separate when setting up the track, i.e.
no connecting rail from Exclusiv/Evolution may be used together
with the connecting rail and Black Box of the Carrera DIGITAL 124/132,
even if only one of the two connecting rails (Exclusiv/Evolution con-
necting rail or Carrera DIGITAL 124/132 connecting rail and Black
Box) is attached to the current supply. Furthermore, no other Car-
rera DIGITAL 124/132 components (switches, electronic lap counter,
pit stop) may be built into an Exclusiv/Evolution course, i.e. via ana-
log operation.
Non-compliance with the above information may result in damage or
destruction of the respective Carrera DIGITAL 124/132 components.
In this case no warranty may be claimed.
Troubleshooting
Driving tips

In case of any malfunctions, please check the following:
Has the connection to the power supply been established cor-
rectly?
Have transformer and speed controllers been connected
correctly?
Are the track connections faultless?
Are the racetrack and track slots clean and free of any foreign
objects?
Are the sliding contacts in order and do they make contact with
the track slot?
• Are the cars correctly coded to the according speed controller?
The track‘s current feed will be switched o automatically for 5
seconds, if there is an electrical short circuit: this will be notied by
audible and visual signals.
Are the cars placed on the track in running direction? In case of
non-functioning push the running direction switch which is on the
car´s bottom.

During operation small car parts as spoilers or mirrors may get o or
brake due to being original detailed parts of the car model. To avoid
this it is possible to remove them before operation.

You can drive fast along the straight track but you should brake
before the curve and then accelerate again when coming out of the
curve.
Do not fasten or block the vehicles when the motor is running:
overheating or damage to the motor could result otherwise.
 When using track systems which are not manufactured by
Carrera the existing guide keel has to be replaced by the special
guide keel (#85309). While using the Carrera crossing (#20587) or
high banked curve 1/30° (#20574) slight driving noise might occur
which is due to the full-scale genuineness and does not aect aw-
less operation.
All Carrera spare parts are available in the webshop:

10


Need help? Post your question in this forum.

Forumrules
1

Forum

carrera-digital-124---30353-driver-display

Reset search

  • My crossover section will work one way and not the other. What can I check? Submitted on 6-8-2022 at 23:49

    Reply Report abuse
  • Installed Driver Displays but they will not see or keep my car addresses. Instructions are useless and do not explain why the car address is not seen by the displays. Display shows correct car address for few seconds then it disappears and is replaced by the dash. Display does not see the car with the corresponding address for either speed or tank function. Why is this not working? How do you set the car up so the Display holds the correct address. Submitted on 20-1-2022 at 00:11

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrera Digital 124 - 30353 Driver Display at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrera Digital 124 - 30353 Driver Display in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 10,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info