550542

Carrera Digital 124 - 23613 GENTLEMEN RACE Manual

13
Zoom out
Zoom in
Previous page
1/26
Next page
13
Connections (from left to right):
1
Connection for Lap Counter 30342
2
Connection for PC-unit or Lap Counter 30355
3
Connector 1 for speed controller, speed controller extension set
or WIRELESS+ receiver
4
Connector 2 for WIRELESS Tower 10108
5
Connector 3 for speed controller
6
Connector 4 for speed controller
7
Connection for DIGITAL 124 / DIGITAL 132 power supply
General information on connectors 1-4:
When a WIRELESS+ receiver is used, it must be plugged into con-
nector 1. Optionally a WIRELESS Tower 10108 can be plugged into
connector 2. When only the WIRELESS+ receiver is used, connec-
tor 2 is to be left empty.
Additional wired speed controllers may be plugged into connectors
3 and 4. Please note that these will use address 5 and 6 then.
Using the speed controller extension set 30348 it has to be plugged
into connector 1. The cars´ addresses will be allocated as follows:
• Speed controller extension set = address 1, 3 and 4
• connector 2 = address 2
• connector 3 = address 5
• connector 4 = address 6
Note:
a combination of WIRELESS and speed controller extension set is
not possible!
Connections Control Unit
1 52 63 74
Connecting the receiver
Connect the receiver according to the symbol to either of the two
sockets on the control unit which are marked Tower 1 and Tower 2.
For operating six WIRELESS+ speed controllers only one 2.4 GHz
receiver is required.
Symbols
SET
C
H
A
N
N
E
L
Connecting the charging unit
The charging unit is connected at the rear of the control unit. To site
the charging unit at any other place on the track, an adapter unit
30360 will be needed.
Rear view of the
control unit
Connecting the Position Tower
AU
PT
The Position Tower
is suitably connected to the Adapter Unit
; the latter can be positioned at any place within the racetrack.
Displays
21
1 a
1 b
1
Two-digit LED-segment display to indicate the number of laps
1
a
Display 100 laps
1
b
Display 200 laps
2
One-digit LED-segment display to indicate race position of 6
cars maximum
Charging the speed controllers
Before first being used, the WIRELESS+ speed controllers should
be fully charged. Place the speed controllers in the charging station
and switch on the control unit. While the unit is charging, the LEDs
1
on the speed controllers will flash. When charging is completed,
the LEDs
1
will light up continuously.
When using a lithium polymer rechargeable battery, it is possible to
top up the speed controller at any time.
1 1
Binding process
2
SET
CHANNEL
1
2
3
1
SET
CHANNEL
1
4
2
1
3
SET
CHANNEL
1
2
3
Before the speed controller can be used to control the cars, it must
be “bound” to the receiver.
To do this, switch on the control unit.
1
The receiver indicates it is ready for operation by a revolving light
signal in the segment display
1
.
2
Push the “SET” button
2
once until the figure 1 appears in the seg-
ment display
1
. The number shown is then the address of the car.
Switch to the next address by further pressing the button.
Now press the binding button
3
on the top of the speed controller.
The speed controller signals a successful binding process with
flashing of the LED, while the receiver indicates it by revolving lights
in the segments. The binding process is now complete and the
speed controller is ready for use.
3
To bind the second speed controller, follow the same procedure.
Press the “SET” button
2
on the receiver twice, until the figure
2 appears
1
. Then press the binding button
3
on the second
speed controller.
4
To display the address set for the speed controller, press once on
the binding button
2
on the top of the speed controller.
The LED
1
will then flash, according to the address set.
If the speed controller is not actuated, it switches automatically after
about 20 seconds into energy-saving mode. The speed controller
can be reactivated by pressing the tappet or the lane-change button.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrera Digital 124 - 23613 GENTLEMEN RACE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrera Digital 124 - 23613 GENTLEMEN RACE in the language / languages: English, German, French as an attachment in your email.

The manual is 9,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info