469905
7
Zoom out
Zoom in
Previous page
1/8
Next page
13
Setting basic speed
1 – 10
1 – 10
(individually for one and/or several cars)

1. Switch o Black Box, place car/s on the track, eect coding of
WIRELESS speed controller to speed controller 1 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button during Black Box is switched
on again. Don´t release the lane-change-button until the 1st LED
lights red. Levels are set by pushing lane-change-button. Conrm
speed by pressing the speed controller´s tappet (thumb) (=> middle
LED will light).
1 LED on = low speed
5 LEDs on = high speed
Setting braking effect
1 – 10
1 – 10
(individually for one and/or several cars)

1. Switch o Black Box, place car/s on the track, eect coding of
WIRELESS speed controller to speed controller 2 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button during Black Box is switched
on again. Don´t release the lane-change-button until the 1st LED
lights red. Levels are set by pushing lane-change-button. Conrm
braking eect by pressing speed controller´s tappet (thumb) (=>
middle LED will light). Before the start return speed controller to the
original connector!
1 LED on = low braking eect
5 LEDs on = high braking eec
Setting fuel tank capacity
Pit Stop 30346
1 – 10
1 – 10
(individually for one and/or several cars)
Activate fuelling function at the Black Box.

1. Switch o Black Box, place car/s on the track, eect coding of
WIRELESS speed controller to speed controller 3 as per point „Cod-
ing/Decoding“.
2. Switch on WIRELESS speed controller located on lower side
(ON/OFF switch).
3. Press and hold lane-change-button
during Black Box is switched on again. Don´t release the lane-
change-button until the 1st LED lights red. Fuel capacity is set
by pushing lane-change-button. Conrm by pressing speed con-
troller´s tappet (=> middle LED will light).
Before the start return speed controller to the original connector!
1 LED on = low fuel capacity
5 LEDs on = full tank

Depending on the fuel capacity the car´s lights start to ash after
some time, the car slows down and might start to stutter. For refuel-
ling enter the Pit Stop and release the speed controller´s tappet.
(Fuelling amount depends on car´s standing time in the Pit Stop).
a) Filling up: wait until car´s lights stop ashing.
b) Partial refuelling: start while car´s lights still ash.
c) Non-refuelling: car drives on at reduced speed.
Maintenance and care
To ensure a proper operation of the motor-racing circuit, all race-
track components should be regularly cleaned. Pull the plug prior to
cleaning.
 Keep the track surface and track slots clean with a
dry cloth. Do not use any solvents or chemicals for cleaning. When
it is not in use, store the racetrack in a clean and dust-protected
location, preferably in the original cardboard box.
 Clean axle and wheel bearings, pinion gears, gear-
wheels and bearings and lubricate using a resin- and acid-free
grease. You can use a toothpick or similar as aid. Regularly check
the condition of sliding contacts and tyres..
Troubleshooting
Driving tips

In case of any malfunctions, please check the following:
Has the connection to the power supply been established cor-
rectly?
Have transformer and speed controllers been connected
correctly?
Are the track connections faultless?
Are the racetrack and track slots clean and free of any foreign
objects?
Are the sliding contacts in order and do they make contact with
the track slot?
• Are the cars correctly coded to the according speed controller?
The track‘s current feed will be switched o automatically for 5
seconds, if there is an electrical short circuit: this will be notied by
audible and visual signals.
Are the cars placed on the track in running direction? In case of
non-functioning push the running direction switch which is on the
car´s bottom.
Please take into account that exposing the Carrera WIRELESS
System for Carrera DIGITAL 124/132 to direct or strong extraneous
light (sunlight, halogen lamps, neon lamps and big at screens) may
result in malfunctions.
Double encoding of the speed controllers will be indicated by the
LED ashing quickly.
Should operation be impossible despite the speed controllers and
Black Box having being switched on, please check the connection
between Receiver/Tower and Black Box.
In case the receiving radius decreases or the cars´ driving charac-
teristics deteriorate please check the batteries.

During operation small car parts as spoilers or mirrors may get o or
brake due to being original detailed parts of the car model. To avoid
this it is possible to remove them before operation.

You can drive fast along the straight track but you should brake
before the curve and then accelerate again when coming out of the
curve.
Do not fasten or block the vehicles when the motor is running:
overheating or damage to the motor could result otherwise.
 When using track systems which are not manufactured by
Carrera the existing guide keel has to be replaced by the special
guide keel (#85309). While using the Carrera crossing (#20587) or
high banked curve 1/30° (#20574) slight driving noise might occur
which is due to the full-scale genuineness and does not aect aw-
less operation.
All Carrera spare parts are available in the webshop:

Delivery exclusively to Germany, Austria, Netherlands, Belgium and
Luxembourg..
Technical specifications

18 V
54 VA
18 V 43,2 VA

6 x 1.5 V Mignon batteries (AA/R6).
Batteries are not included in delivery.

It is not possible to use rechargeable batteries.

1.) Operating mode = cars are operated via speed controllers
2.) Idle mode = speed controllers not activated, no game
3.) Stand-by mode = after approx. 20 minutes idle mode the
connecting section switches to stand-by mode. LED ashes at
long intervals.
By operating the speed controller the stand-by mode is nished,
the racetrack returns to idle-mode again.
4.) O-state = power supply unit disconnected from mains supply
This device is marked by “selective sort throught” symbol related to
sort through domestic, electric and electronic, waste.
This means the product must be treated by a specialized “sorting/
collecting” system in accordance with European directive 2002/96/
CE, to reduce the impact upon environment.
For more precise information, please contact your local administra-
tion.
Electronical product which are not going through special collect-
ing, are potentially dangerous for environment and human health,
because of dangerous substance.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrera Digital 124 - 23608 Race Competition en WIRELESS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrera Digital 124 - 23608 Race Competition en WIRELESS in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 3,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info