551126
11
Zoom out
Zoom in
Previous page
1/68
Next page
7 11
8
5 9
6 10
11
12
1
2 3
OFF
OFF
OFF
Problem Cause Solution
The Lap Counter is not
working
No battery, or too weak a battery, in the Lap Counter
Replace the batteries in the Lap Counter. Make sure you switch off the
Lap Counter after using it (page 11, Fig. 12)
The Lap Counter has a temporary malfunction
Press the small round Soft Reset” button above the button on the
traffic light module
Wrong lap number shown on
the controller display
Another participant has set a greater number of laps than you have
Check the controllers of all the participants as described on page 10.
Alter the number of laps on the participants’ controllers to a lower
gure than that shown on the first controller
The lap number on the
controller is not changing
The sensor on the car is dirty
Please clean the sensor, which is located on the underneath of the car
between the front wheels
The ribbon bre-optic cable is dirty Clean the ribbon bre-optic cable
The ribbon fibre-optic cable is not correctly connected to the Lap
Counter modules
Check the connection of the ribbon fibre-optic cable with the Lap
Counter modules (page 10)
The controller does not switch
over to race mode
No battery, or too weak a battery, in the Lap Counter Replace the batteries in the Lap Counter
The Lap Counter is not in running lights mode
Start the running lights mode as described on page 11 (see page 11,
Figs 5-7)
The Lap Counter has a temporary malfunction
Press the small round Soft Reset” button above the button on the
traffic light module
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
Now switch on the previously programmed
controller and the display switches auto-
matically into RACE mode. Any other con-
troller within range will now log on automati-
cally, so make sure that when you switch on
the first controller, there are no other con-
trollers switched on. Now all the other com-
petitors in the race can switch on their con-
trollers. Check the number of participants.
Switch the Carrera RC Lap Counter
on at the left-hand side of the traffic
light module.
Press once on the button on the traffic
light module.
Once all participants are logged on,
press once again on the button on the
traffic light module (about 3 seconds)
and the starting sequence commences.
As soon as the traffic light changes to
green, the race can start.
On the display you will now see the
race time and your position, each time
you cross the start-finish line, as well as
your fastest lap.
For a new start, press the button on the
traffic light module for one second so
that the traffic light switches into run-
ning mode again (see Fig. 7).
After the race, always switch off the
model first, then the controller and Lap
Counter.
The light switches into running light
mode and starts to look for participants.
Troubleshooting
Should you need spare parts, you will find a complete list of the available parts under carrera-rc.com in the service area.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrera 800025 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrera 800025 in the language / languages: All languages as an attachment in your email.

The manual is 15,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info