550576
14
Zoom out
Zoom in
Previous page
1/46
Next page
14
Codierung
Wireless Handregler
Encoding Wireless
speed controller
Codage commande
manuelle Wireless
Die Einstellung bzw. Zuordnung der 4
möglichen Frequenzen wird an der Ober-
seite des Wireless Handreglers vorgenom-
men (Abb. ). An der Unterseite finden Sie
die Zuordnungstabelle (Abb. und ).
Um dem Wireless Handregler ein Fahrzeug
zuzuordnen, stellen Sie die Umschalter am
Wireless Handregler wie in Abb. ge-
zeigt ein.
Bitte beachten Sie folgende
Vorgehensweise:
1. Einstellung des Handreglers gemäß
Abb. – .
2. Einschalten des Wireless Handreglers
durch den ON/OFF Schalter an der Hand-
reglerunterseite (Abb. ).
Sollte das Fahrzeug nicht fahren, codieren
Sie das Fahrzeug zu dem entsprechenden
Handregler gemäß Seite 25.
Die veränderbaren Funktionen (Einstellung
Grundgeschwindigkeit, Bremswirkung,
Tankinhalt) werden ebenfalls über die
Handregler programmiert. Dazu müssen
die Handregler auf die entsprechende
Codierung (s. Abb. ) eingestellt werden.
Sollte, während der Handregler in Betrieb
ist, die Frequenz geändert werden, so
wird die Änderung erst nach erneutem
Einschalten (ON/OFF Schalter an der
Unterseite) des Wireless Handreglers
übernommen. Eine Änderung der Frequenz
während des Spielbetriebs ist NICHT
möglich.
Der Wireless Handregler schaltet bei Nicht-
benutzung automatisch nach 2 Min. in
den Standby Modus und wird erst durch
Betätigen des Handreglers wieder aktiviert.
Tuning / assignment of the 4 possible fre-
quencies is carried out at the top of the
Wireless speed controller (Fig. ). At the
bottom you will find the assignment table
(Fig. and ). To assign a car to the
Wireless speed controller please set the
control at the Wireless speed controller
as shown in figure .
Please note the following procedures:
1. Setting of the speed controller as shown
in Fig. – .
2. Switching on the Wireless speed con-
troller using the ON/OFF switch on the
lower side of the speed controller (Fig. ).
If the car does not operate, then code the
car to corresponding speed controller as
shown on page 25.
The modifiable functions (setting of the
ground speed, braking action, level of fuel
in the tank) are likewise programmed by
means of the speed controller. For this
purpose the speed controller must be set
to the corresponding coding (cf. Fig. ).
In case the frequency shall be changed
while the speed controller is being oper-
ated, the change will only be effected
after the Wireless speed controller has
been switched on again (ON/OFF switch
at the bottom). It is NOT possible to
change the frequency during operation.
Has the Wireless speed controller not
been used for a period of 2 minutes it
automatically turns into the standby mode
and is only activated when operating the
speed controller again.
Le réglage et l’attribution des 4 fréquen-
ces possibles sont effectués sur la face
supérieure du dispositif de commande
manuelle Wireless (Fig. ). La liste
d’attribution se trouve sur le dessous de
l’appareil (Fig. et ). Pour attribuer
un véhicule à la commande manuelle
Wireless, régler les commutateurs de la
commande manuelle Wireless comme
indiqué dans Fig. .
Veuillez exécuter les opérations
suivantes :
1. Réglez le régulateur manuel comme
indiqué aux figures – .
2. Mettez en marche le régulateur ma-
nuel Wireless en actionnant le bouton
Marche/Arrêt au dessous du régulateur
(Fig. ).
Si la voiture ne roule pas, veuillez coder
la voiture en fonction du régulateur
manuel correspondant comme indiqué
page 25.
1 2
1
2
3
2
1
2
3
2
1
2
3
2
1 3
4
5
5
1 3
4
1 3
4
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carrera 30133 Longdistance at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carrera 30133 Longdistance in the language / languages: English, German, French, Portuguese, Spanish as an attachment in your email.

The manual is 4,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info